INSTALLATION
2000 Autoflow
Plenum Temperature Sensor
The plenum temperature sensor is the small grey PVC junction box at- tached by a cord to the fan/heater control box on the master fan/heater unit.
1.On either side of the fan/heater, drill one 3/4” hole even with the fan/heater unit in a valley on the bin sidewall.
2.Insert the probe through the 3/4” hole.
3.Position the housing so the cord exits the housing horizontally, and the tabs fall on the sidewall peaks.
4.Use two self drilling screws to mount the housing to the bin sidewall.
5.Caulk between the housing and the sidewall to seal.
Important!
If the Top Dry is a two fan unit, do not mount the plenum tem- perature sensor between the two fan/heater units.
Plenum temperature sensor on the bin sidewall.
18