INSTALLATION
2000 Autoflow
Fan and Heater Mounting
1.Inspect the fan platform for proper installation per instructions in the Top Dry erection manual.
2.Raise the Top Dry fan and heater units to the plat form. Use the table to the right to determine the height of the platform from the base of the TopDry unit.
3.Mount the Top Dry fan and heater units to the bin entrance sheets. Fan legs should set on the plat form.
Top Dry Bin Eave Height
Number Eave
of Rings Height
5
6
7
8
9
10
11
Autoflow Control Box Mounting
Save for Control box mounted on Bin picture
Autoflow Control box mounted on bin.
1.The Autoflow Control Box should be mounted at
2.Keep in mind that wire will be used to inter connect the Autoflow control Box with the
fan and heater unit(s), Fill System Control Box, Actuator and all rotary switches.
3.Use the hole pattern in Figure 1 to drill holes for mounting the Autoflow Control Box.
8