Bosch Power Tools 1942 manual Important Safety Instructions for Heat Guns

BM 2610615924 2/02 2/1/02 12:36 PM Page 2

Important Safety Instructions for Heat Guns

!WARNING Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury.

Hidden areas such as behind walls, ceilings, floors, soffit boards and other panels may contain flammable materials (dust, cob webs, mice nests, etc.) that could be ignited by the heat gun when working in these locations. The ignition of these materials may not be readily apparent and could result in property damage and injury to persons.

When working in locations that may have hidden areas, keep the heat gun moving in a back-and-forth motion. Lingering or pausing in one spot could ignite the panel or the material behind it.

Paint Stripping Safety Instructions

!WARNING Extreme care should be taken when stripping

paint. The peelings, residue and vapors of paint may contain lead, which is poisonous. Any pre-1977 paint may contain lead and paint applied to homes prior to 1950 is likely to contain lead. Once deposited on surfaces, hand to mouth contact can result in the ingestion of lead. Exposure to even low levels of lead can cause irreversible brain and nervous system damage; young and unborn children are particularly vulnerable. Before beginning any paint removal process you should determine whether the paint you are removing contains lead. This can be done by your local health department or by a professional who uses a paint analyzer to check the lead content of the paint to be removed. LEAD-BASED PAINT SHOULD ONLY BE REMOVED BY A PROFESSIONAL AND MUST NOT BE REMOVED USING A HEAT GUN.

Persons removing paint should follow these guidelines:

1)Move the work piece outdoors. If this is not possible, keep the work area well ventilated. Open the windows and put an exhaust fan in one of them. Be sure the fan is moving the air from inside to outside.

2)Remove or cover any household items in the area such as carpets, rugs, furniture, and clothing, cooking utensils and air ducts.

3)Place drop cloths in the work area to catch any paint chips or peelings. Wear

protective clothing such as extra work shirts, overalls and hats.

4)Work in one room at a time. Furnishings should be removed or placed in the center of the room and covered. Work areas should be sealed off from the rest of the dwelling by sealing doorways with drop cloths.

5)Children, pregnant or potentially pregnant women and nursing mothers should not be present in the work area until the work is done and all clean up is complete.

6)Wear a dust respirator mask or a dual filter (dust and fume) respirator mask, which has been approved by the Occupational Safety and Health Administration (OSHA), the National Institute of Safety and Health (NIOSH), or the United States Bureau of Mines. These masks and replaceable filters are readily available at major hardware stores. Be sure the mask fits. Beards and facial hair may keep masks from sealing properly. Change filters often. DISPOSABLE PAPER MASKS ARE NOT ADEQUATE.

7)Use caution when operating the heat gun. Keep the heat gun moving, as excessive heat will generate fumes that can be inhaled by the operator.

8)Keep food and drink out of the work area. Wash hands, arms and face and rinse mouth before eating or drinking. Do not smoke or chew gum or tobacco in the work area.

SAVE THESE INSTRUCTIONS

-2-