REMOTE CONTROLLER SIGNAL CODE SETTING
Use the following steps to select the signal code of the remote controller. (Note that the air conditioner cannot receive a signal code if the air conditioner has not been set for the signal code.)
(1)Press the MODE button for at least 5 seconds to display the current signal code. (initially set to 
).
(2) Press the SET TEMP.(
) (
) button to change the signal code
between 
.
Match the code on the display to the air conditioner signal code.
(3) Press the MODE button again. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the display returns to the original status. In this case, start again from step 1.
The air conditioner signal code is set to 
prior to shipment.
Contact your retailer to change the signal code.
The remote controller resets to signal code 
when the batteries in the remote controller are replaced. If you use a signal code other than signal code 
, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
) until you find the code which operates the air conditioner.