Honeywell UDC 3300 A1S2TYPE A2S1TYPE A2S2TYPE, High LOW Begin END, High Alarm LOW Alarm, A2S2 EV

Lower Display

Prompt

A1S2TYPE

A2S1TYPE

A2S2TYPE

A1S1 H L

A1S1 EV

Upper Display

Range of Setting

or Selection

Same as A1S1 TYPE

Same as A1S1 TYPE

Same as A1S1 TYPE

HIGH

LOW

BEGIN

END

Parameter

Definition

ALARM 1 SETPOINT 2 TYPE— Select what you want Setpoint 2 of Alarm 1 to represent.

The selections are the same as A1S1TYPE.

ALARM 2 SETPOINT 1 TYPE— Select what you want Setpoint 1 of Alarm 2 to represent.

The selections are the same as A1S1TYPE.

ATTENTION Not applicable with Relay Duplex or Position Proportional outputs.

ALARM 2 SETPOINT 2 TYPE— Select what you want Setpoint 2 of Alarm 2 to represent.

The selections are the same as A1S1TYPE.

ATTENTION Not applicable with Relay Duplex or Position Proportional outputs.

If Setpoint Programming is disabled or if the Alarm Type is not configured for Event On/Off:

ALARM 1 SETPOINT 1 STATE— Select whether you want the alarm type chosen in prompt A1S1TYPE to alarm High or Low.

HIGH ALARM

LOW ALARM

If Setpoint Programming is enabled and if the Alarm Type is configured for Event On/Off:

ALARM 1 SEGMENT EVENT 1— Select whether you want the alarm type chosen in prompt A1S1TYPE to alarm the beginning or end of a segment in setpoint Ramp/Soak programming.

BEGINNING OF SEGMENT

END OF SEGMENT

ATTENTION Alarms configured for events will not operate on Setpoint Program segments of zero length.

A1S2 H L	HIGH
	LOW
A1S2 EV	BEGIN
	END
A2S1 H L	HIGH
	LOW
A2S1 EV	BEGIN
	END
A2S2 H L	HIGH
	LOW
A2S2 EV	BEGIN
	END

ALARM 1 SETPOINT 2 STATE— Same as A1S1 H L.

ALARM 1 SEGMENT EVENT 2— Same as A1S1 EV.

ALARM 2 SETPOINT 1 STATE— Same as A1S1 H L.

ALARM 2 SEGMENT EVENT 1— Same as A1S1 EV.

ALARM 2 SETPOINT 2 STATE— Same as A1S1 H L.

ALARM 2 SEGMENT EVENT 2— Same as A1S1 EV.

4/00 UDC 3300 Process Controller Product Manual 141