Honeywell UDC 3300 manual Configuration Tips

3.4Configuration Tips

Introduction	Listed below in Table 3-1 are some tips that will help you enter the
	configuration data more quickly.
	Table 3-1	Configuration Tips

Function

Displaying Groups

Displaying

Functions

Scrolling

Changing values

quickly

Restoring to the

original value

Exiting SET UP

mode

Timing out from

Set Up mode

Key Error

Tip

Use the SET UP key to display the Set Up groups. The group titles are listed in this

section in the order that they appear in the controller.

Use the FUNCTION key to display the individual parameters under each group. The

prompts are listed in the order of their appearance in each group.

To get to a Set Up group prompt more quickly, hold the SET UP key in. To get to a

Function prompt more quickly, hold the			FUNCTION	key in. The display will scroll through
the parameters.
	ATTENTION	The prompting scrolls at a rate of 2/3 seconds when the			SET UP	or
	FUNCTION	key is held in. Also, [ ] [	] keys will move group prompts forward or
backward at a rate twice as fast.

When changing the value of a parameter, you can use a single [] or [] key. Hold the key in to increase the rate of change. Stop pressing the key for 1/2 second, then press again to restart at a slow rate.

When changing the value of a parameter, you can adjust a more significant digit in the upper display by holding in one key [] or [], and pressing the other [] or [] at the same time. The adjustment will move one digit to the left. Press the key again and you will move one more digit to the left. (Holding the [] and [] keys down will change the value twice as quickly.)

When you change the value or selection of a parameter while in Set Up mode and decide not

to enter it, press	RUN/HOLD	once, the original value or selection will be recalled.
To exit Set Up mode, press the		LOWER DISPLAY	key. This returns the display to the same

state it was in immediately preceding entry into the Set Up mode.

If you are in Set Up mode and do not press any keys for 30 seconds, the controller will time out and revert to the mode and display that was being used prior to entry into Set Up mode.

When a key is pressed and the prompt “KEY ERROR” appears in the lower display, it will be for one of the following reasons:

• parameter not available

• not in Set Up mode, press SET UP key first

•key malfunction, do keyboard test (operation)

•Individual key locked out

4/00 UDC 3300 Process Controller Product Manual 39