Honeywell UDC 3300 Power-up state, Viewing the number of cycles left in the program End Program

Function

Viewing the number of cycles left in the program

End Program

Press

LOWER DISPLAY

Result

until you see

Upper Display

“R” and the PV value

Lower Display

RECYC XX

Remaining Cycles 0 to 99 This number does not include the current partially completed cycle.

When the final segment is completed, the “R” in the upper display either changes to “H” if configured for HOLD state, or disappears if configured for disable of setpoint programming.

The controller operates at the last setpoint in the program in automatic or will be in manual mode at the failsafe output.

Power-up state

The program will be placed in HOLD mode at the beginning of the program at the local setpoint value prior to the beginning of the program.

216 UDC 3300 Controller Product Manual 4/00