Segment Characterizer #2- a second eight

Lower Display

Prompt

Upper Display

Range of Setting

or Selection

8SEG CH2		8 SEGMENT CHARACTERIZER #2— A second eight
		segment characterizer can be applied to either
		Input 1, Input 2, Output 1, or Output 2.
	DISABL	DISABLE— Disables characterizer.
	INPUT1	INPUT 1— Characterizer applied to Input 1.
	INPUT2	INPUT 2— Characterizer applied to Input 2.
	L1 OUT	LOOP 1 OUTPUT— Characterizer applied to Loop 1
		Output. (NOTE 1)
	L2 OUT	LOOP 2 OUTPUT— Characterizer applied to Loop 2
		Output.
		There are eight (Xn) Input values and eight (Yn) Output
		values to be selected. The following rules apply:
		• When Input 2 is used, Input 2 Ratio and Bias are
		applied to the Xn Values.
		• When one of the Loop outputs are selected, the Xn
		Input values are the Output from the control algorithm,
		and the Yn Output is the final control element action.
		This application is useful for non-linear control elements
		or Process Variable.
		A simple example is shown in Figure 4-2.

ATTENTION The X values below should be entered as increasing values (from 0% to 100%) from N=0 to 8.

4/00

UDC 3300 Process Controller Product Manual

105

Honeywell UDC 3300 manual Segment Characterizer #2- a second eight, X0 VALU2