Honeywell UDC 3300 manual Security Lockout Auto MAN SP SEL RUN Hold

Lower Display

Prompt

SECURITY

LOCKOUT

AUTO MAN

SP SEL

RUN HOLD

Upper Display

Range of Setting

or Selection

0 to 4095

NONE

CALIB

+CONF

+VIEW

MAX

DISABL

ENABLE

DISABL

ENABLE

DISABL

ENABLE

Parameter

Definition

SECURITY CODE— The level of keyboard lockout may be changed in the Set Up mode. Knowledge of a security code may be required to change from one level to another. Select this number here, copy it, and keep it in a secure location.

NOTE: The Security Code is for keyboard entry only and is not available via communications.

Can only be changed if LOCKOUT selection is NONE.

LOCKOUT applies to one of the functional groups: Configuration, Calibration, Tuning, Accutune. DO NOT

CONFIGURE UNTIL ALL CONFIGURATION IS COMPLETE.

NONE— No lockout; all groups are read/write.

CALIB— All groups are available for read/write except for the Calibration and Keyboard Lockout groups.

+CONF— Tuning, SP Ramp, and Accutune groups are read/write. All other groups are read only. Calibration and Keyboard Lockout groups are not available.

+VIEW— Tuning and Setpoint Ramp parameters are read/write. No other parameters are viewable.

MAX— Tuning and Setpoint Ramp parameters are available for read only. No other parameters are viewable.

MANUAL/AUTO KEY LOCKOUT— Allows you to disable the Manual/Auto key.

Disable

Enable

Can only be viewed if LOCKOUT is configured for NONE.

SETPOINT SELECT KEY LOCKOUT— Allows you to disable the Setpoint Select key.

Disable

Enable

Can only be viewed if LOCKOUT is configured for NONE.

RUN/HOLD KEY LOCKOUT— Allows you to disable the Run/Hold key, for either SP Ramp or SP Program. The Run/Hold key is never disabled when used to acknowledge a latched alarm 1.

Disable

Enable

Can only be viewed if LOCKOUT is configured for NONE.

82 UDC 3300 Process Controller Product Manual 4/00