Honeywell UDC 3300 manual Configuration Prompt Definitions

Section 4 – Configuration Prompt Definitions

4.1 Overview

Introduction

What’s in this section?

This section provides information for all the user configurable parameters listed in Section 3 - Configuration. If you are not familiar with these parameters, this section gives you the parameter prompt, the selection or range of setting that you can make, and a definition of how each parameter setting affects controller performance. It will also refer you to any other prompts that might be affected by your selection.

The table below lists the topics that are covered in this section. They are listed in the order of their appearance in the controller.

	Topic	See Page
4.1	Overview	79
4.2	Loop 1 Tuning Parameters Set Up Group	80
4.3	Loop 2 Tuning Parameters Set Up Group	84
4.4	Setpoint Ramp/Rate/Programming Set Up Group	85
4.5	Accutune Set Up Group	88
4.6	Algorithm Data Set Up Group	92
4.7	Output Algorithm Set Up Group	109
4.8	Input 1 Set Up Group	112
4.9	Input 2 Set Up Group	116
4.10	Input 3 Set Up Group	117
4.11	Loop 1 Control Set Up Group	118
4.12	Loop 2 Control Set Up Group	124
4.13	Options Set Up Group	129
4.14	Communications Set Up Group	135
4.15	Alarms Set Up Group	139
4.16	Display Parameters Set Up Group	143
4.17	Calibration Data	144
4.18	Maintenance Set Up Group	144
4.19	Status Test Data	146

4/00 UDC 3300 Process Controller Product Manual 79