Honeywell UDC 3300 Status Test Data, Failure. Refer to the Troubleshooting in this manual for

Lower Display

Prompt

(continued)

COUNTS1

COUNTER2

COUNTS2

COUNTER3

COUNTS3

PASSWORD

RES TYPE

Upper Display

Range of Setting

or Selection

TUNE2

0-9999 (1 = 1000 counts for output relays 1 and 2)

Same as COUNTER1

Same as COUNTS1

Same as COUNTER1

Same as COUNTS1

0-9999

NONE

TIMER1

TIMER2

TIMER3

ALL TM

COUNT1

COUNT2

COUNT3

ALL CO

ALL TC

Parameter

Definition

Failsafe mode.

LOOP 2 TUNE— Number of times Loop 2 has been tuned (manually and automatically).

Shows the value of Counter 1. Read only.

Counter 2 counts the number of times the selected event has occurred.

Shows the value of Counter 2. Read only.

Counter 3 counts the number of times the selected event has occurred.

Shows the value of Counter 3. Read only.

PASSWORD—Entering the designated number resets to zero the timer or counter specified by Reset Type.

To designate a number as the password:

1.Set all timers and counters to DISABL.

2.Enter the desired PASSWORD (0-9999).

3.Select a Reset Type (next prompt). The PASSWORD

goes into effect when you press FUNC , that is, you can

use it to reset the counters and timers.

RESET TYPE—Select which timers and/or counters will be reset to zero when the PASSWORD is entered.

NONE— No values will be reset

TIMER 1 will be reset

TIMER 2 will be reset

TIMER 3 will be reset

ALL TIMERS will be reset

COUNTER 1 will be reset

COUNTER 2 will be reset

COUNTER 3 will be reset

ALL COUNTERS will be reset

ALL TIMERS AND COUNTERS will be reset

4.19 Status Test Data

Introduction	The prompts used here are for determining the reason for a controller
	failure. Refer to the Section 8 – Troubleshooting in this manual for
	complete information.

146 UDC 3300 Process Controller Product Manual 4/00