Mounting method

Before mounting the controller, refer to the nameplate on the inside of the case and make a note of the model number. It will help later when selecting the proper wiring configuration.

Figure 2-3 shows you the mounting method for the UDC 3300 controller.

Figure 2-3 Mounting Method

Panel

 

22605

Mounting procedure

 

Refer to Figure 2-3 and follow the procedure in Table 2-2 to mount the

 

controller.

Step

1

2

3

4

Table 2-2 Procedure for Mounting the Controller

Action

Mark and cut out the controller hole in the panel according to the dimension information in Figure 2-2.

Remove the screw cover and loosen the screw on the front of the controller. Pull the chassis out of the case.

Orient the case properly and slide it through the panel hole from the front.

Remove the mounting kit from the shipping container, and install the kit as follows:

Install the screws into the threaded holes of the clips.

Insert the prongs of the clips into the two holes in the top and bottom of the case.

Tighten both screws to secure the case against the panel.

Carefully slide the chassis assembly into the case, press to close and tighten the screw. Replace the screw cover.

14

UDC 3300 Controller Product Manual

4/00

Page 26
Image 26
Honeywell UDC 3300 Refer to -3 and follow the procedure in -2 to mount, Controller, Mounting method, Mounting procedure