Honeywell UDC 3300 manual Configuration Procedure, Introduction Procedure, Press, Result

3.5Configuration Procedure

Introduction

Procedure

Each of the Set Up groups and their functions are pre-configured at the factory.

The factory settings are shown in Tables 3-3 through 3-18 which follow this procedure.

If you want to change any of these selections or values, follow the procedure in Table 3-2. This procedure tells you the keys to press to get to any Set Up group and any associated Function parameter prompt.

If you need a detailed explanation of any prompt, refer to Section 4 –

Configuration Parameter Definitions.

Follow the procedure listed in Table 3-2 to access the Set Up groups and Function prompts.

ATTENTION The prompting scrolls at a rate of 2/3 seconds when the SET UP or FUNCTION key is held in. Also, [] [] keys will move group prompts forward or backward at a rate twice as fast.

Table 3-2 Configuration Procedure

Step

1

Operation

Select Set Up mode

Press

SET UP

Result

Upper Display
SET UP	Lets you know you are in the
	configuration mode and a Set Up group
	title is being displayed in the lower
	display.
Lower Display

TUNING * This is the first Set Up group title.

2

Select any Set Up group

SET UP

Successive presses of the SET UP key will

sequentially display the other Set Up group titles shown in the prompt hierarchy in Figure 3-1.

You can also use the [] [] keys to scan the Set Up groups in both directions.

Stop at the Set Up group title which describes the group of parameters you want to configure. Then proceed to the next step.

3

Select a Function Parameter

FUNCTION

LOOP 1/2

Upper Display

1.0Shows you the current value or selection for the first function prompt of the particular Set Up group that you have selected.

Lower Display

GAIN	Shows the first Function prompt within
	that Set Up group.

Example displays show Set Up group “Tuning”, Function prompt “Gain”, and the value selected.

40 UDC 3300 Process Controller Product Manual 4/00