ZT = ZONE TYPE/SYSTEM OPERATION
Choices for Start/Stop Zone Types and System Operations:
00 | = No Response (Not Used) |
| 23 | = No Alarm Response |
| 43 | = Communication failure |
01 | = Entry/Exit #1 | 31 | = End of Exit Time | 44 | = RF Low Battery | ||
02 | = Entry/exit #2 | 32 | = Start of Entry Time | 45 | = Polling Loop Failure | ||
03 | = Perimeter | 33 | = Any Burglary Alarm | 51 | = RF Receiver Failure | ||
04 | = Interior Follower |
|
| = Code + [#] + 71 Key Entry |
|
| = Kissoff |
34 | 52 | ||||||
05 | = Trouble Day/Alarm Night | 35 | = Code + [#] + 72 Key Entry | 54 | = Fire Zone Reset | ||
06 | = |
|
| = At Bell Timeout ** |
|
| = Disarm + 1 Minute |
36 | 55 | ||||||
07 | = | 37 | = 2 Times Bell Timeout ** | 56 | = XX Minutes (enter XX in field 1*74) * | ||
08 | = | 38 | = Chime | 57 | = YY Seconds (enter YY in field 1*75) * | ||
09 | = Fire Alarm or Trouble | 39 | = Fire Alarm | 58 | = Duress | ||
10 | = Interior W/Delay | 40 | = Bypassing | 60 | = Audio Alarm Verification (must be | ||
20 | = | 41 | = AC Power Fail |
|
| selected for both START and STOP | |
21 | = | 42 | = System Battery Low |
|
| operation) | |
22 | = Disarming (Code + Off) |
|
|
|
|
|
|
NOTE: Any zone in "ZT" for Start, going into alarm, fault, or trouble will activate the relay.
Any zone in "ZT" for Stop, that restores will stop the relay action.
*Stop condition only
**Or at Disarming, whichever occurs earlier
***The output also activates when the partition is armed in the INSTANT mode
****The output also activates when the partition is armed in the MAXIMUM mode
P = PARTITION No. 1-8, 0 = Any
ZONE LISTS FOR OUTPUT DEVICES – Programmed in the #93 Menu Mode in the Output Programming Section. Fill in the required data on the worksheet below and follow the procedure shown earlier in this Programming Guide as you enter the data during the displays and prompts that appear in sequence. Up to 8 zone lists may be created
Note: Record desired zone numbers below. More or fewer boxes than shown may be needed, as any list may include any or all of system's zone numbers.
Zone List 1: Started or stopped by zone numbers (enter 00 to end entries).
Zone List 2: Started or stopped by zone numbers (enter 000 to end entries).
Zone List 3: Started or stopped by zone numbers (enter 000 to end entries).
Zone List 4: Started or stopped by zone numbers (enter 000 to end entries).
Zone List 5: Started or stopped by zone numbers (enter 00 to end entries).
Zone List 6: Started or stopped by zone numbers (enter 000 to end entries).
— 40 —