SVAT Electronics CLEARVU11 instruction manual Motion Detection

MAIN MENU

SVAT ELECTRONICS

now you can see

MOTION DETECTION

The Clearvu11 has bulit in motion detection available for each camera . Press ENTER or +/- to check/uncheck this item. The default setting is “” - checked.

MOTION SETTINGS

This is the link used to setup the motion settings for this camera. Press ENTER on Settings to call up Motion Setup menu for the camera.

MOTION SETUP

In Camera Setup, press ENTER to call up Motion Setup as shown when the highlighted option is Settings in the motion setup row for the camera you wish to setup. The Motion setup allows you to define how the system responds to detected motion for the selected camera.

Following is a brief description for each item and its specific operations:

•Duration – response duration to define how long the DVR will record after motion is detected for this camera. Press +/- buttons to adjust the value (3 seconds - 60 minutes, or discrete).

•Goto Preset – to define the preset position to go to if motion is detected (only works with PTZ cameras). For more details about preset locations, please refer to PTZ Control.

•Pre-record– will define how long before motion is detected this camera will record at pre-record IPS. Press +/- buttons to adjust the value (0-10 seconds, discrete). Please note that the actual pre-record time may be shorter than the value set if the total size of the pre-record pictures exceeds the pre-record buffer size of the system.

•Post-record– will define how long after motion is detected this camera will record at the set Event Record IPS. Press +/- buttons to adjust the value (0 second - 60 minutes, or discrete).

• Alarm Out – will define which Alarm Output will be triggered when motion of this camera is detected. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-2).

CLEARVU11 20