SVAT Electronics CLEARVU11 instruction manual Connecting the DVR Using a D-LINK Router Example

NETWORKING GUIDE	SVAT ELECTRONICS
	now you can see

CONNECTING THE DVR USING A D-LINK ROUTER (EXAMPLE)

In this example a D-Link D1-604 router was used. The steps for your router may be similar to the following steps. These instructions have also been created without a firewall in place. If you have a firewall, please consult a computer technician or your network administrator.

You need to configure the router to forward the port numbers that the DVR uses.This will allow a computer over the internet to properly communicate with the DVR. The CLEARVU11 by default uses ports 67, 68, 80. All 3 ports need to be configured.

1.Open your web browser. Enter the ROUTER IP address (default gateway) in the address bar and press ENTER.

2.Enter the user name “admin”. Leave the password blank followed by pressing the OK button (unless you have set up a user name and password for your router).

In this situation, our router username is “admin” and the password is blank. Your router’s default username and password can be found by visiting

www.portfoward.com and following the steps outlined in “Configuring Your Router.”

*If the default username and password are not working, contact your network administrator (or the person who configured your router.)

*It is necessary to log on to your router to configure the port forwarding and access your DVR remotely.

3. Select the Advanced tab.

CLEARVU11 44