NETWORKING GUIDE
SVAT ELECTRONICS
now you can see
NOTE: If you look at the router there should be a green “link” light indicating that the DVR is properly connected to the port that it was plugged into. If this light is on, you can proceed to finding the DVR’s IP Address.
FINDING THE DVR’S IP ADDRESS
Once the DVR is connected to the router you will need to find the IP address of the DVR. This is referred to as the “Internal IP Address” of the DVR.
To check the DVR’s IP address:
1.Press the Menu button.
2.Select Login / Logout.
3.Type in your username and press ENTER. Type in your password and press ENTER.
4.Select Setup and press ENTER.
5.Select Network and press ENTER. You are now at the network setup screen.
6.Make sure the“Net Type” is set to DHCP. This setting is acceptable for most users. If your router does not support DHCP or the DVR needs to store PPPoE (ADSL) settings contact your network administrator or ISP (Internet Service Provider) for the proper IP address settings.
NOTE: By default, the DVR network settings are set to DHCP. This means the DVR will automatically get an IP address from the router when it is connected properly.
7.Write down your IP address, Subnet Mask, Default Gateway, and DNS on the notes section. This information will be used to view the DVR on your computer and also assist in being able to view the DVR over the Internet.
8.Press “ESC” to exit out of Menu. Press ENTER to save changes.
9.Once you see confirmation, Press ENTER again. You have successfully configured your network settings.
CLEARVU11 | 39 |
|
|