MAIN MENU | SVAT ELECTRONICS |
| now you can see |
The general operations are as below:
•▲▼◄►- Press these buttons to select the items. The display will scroll left/right if the selected item is not shown on the screen.
•Numeric
•COPY ( 
) - Press this button to copy all the settings - excluding detailed Motion settings, Video Loss settings, Title/Audio - of the focus camera to all the following cameras. (E.g. focus camera is 1, its settings will be copied to those of cameras
•ESC (MENU/ESC) - Press this button to escape from this screen, and return to Setup Menu display. If the Save dialog is shown, press ENTER to exit and save, ESC (MENU/ESC) to exit without saving.
ALARM SETUP
In Setup Menu display, press ▲▼ to change the highlighted option to Alarm, and then press ENTER to call up Alarm Setup display as shown. The Alarm Setup allows the administrator to define the attributes for each alarm input, and the actions if it’s triggered. There are up to 4 alarm inputs which can be connected to the system.
Following is a brief description for each item and its specific operations:
•Normal State – press +/- buttons to select N/A, Close or Open. Please check the signal type, normally close or normally open, connected to the alarm input terminal on the rear panel of the system. If there’s no signal connected, please select N/A – Not Available, and the following items will not be setup. The default setting is Open.
•Focus Camera – the camera corresponding to this alarm input.
•Duration – response duration to define how long (in seconds) the Alarm Out relay and the Buzzer will stay on for after this alarm input is triggered. However, the Alarm Out relay and the Buzzer will be reset immediately once this alarm input returns to normal. Press +/- buttons to adjust the value
•Goto Preset – to define the preset position to go to for the Focus Camera if this alarm input is triggered (only available for PTZ cameras).
•
CLEARVU11 | 24 |
|
|