New Buck Corporation DV1000 STANDARD VERTICAL CHASE TERMINATION, Installations, 30FT MAX, Page

Page 17

DV1000 STANDARD VERTICAL CHASE TERMINATION

DV1000 STANDARD VERTICAL CHASE TERMINATION

INSTALLATIONS

VERTICAL TERMINATION CAP

ASSEMBLY

30FT.

MAX.

WALL STRAPS

NOTE: Vertical pipe installations must be supported with Wall Straps every 8 feet.

3FT.

MIN.

FLEX PIPE (ONLY)

DV1000 FRONT

FIGURE 11

Page 14

Image 17

Contents Approved By DV1000ZERO CLEARANCE DIRECT VENT GAS FIREPLACE Page TABLE OF CONTENTS Page INSTALLATION AND OPERATION INTRODUCTION AND SAFETY FORDV1000 FIREBOX COVER DOOR REMOVAL INSTRUCTIONS 2. BOTTOM LOUVER ASSEMBLY 1. TOP LOUVER ASSEMBLYLOUVER ASSEMBLY VER ASSEMBLY CLIP TO SECURE TO STOVE BODY38-1/8” 36” 33-1/2” DV1000 SPECIFICATIONS16-15/16” 2-1/2” 6” TOP STANDOFFS SIDE STANDOFFS 27-1/8” 13-9/16”40-1/8” MINIMUM FRAMING DIMENSIONS2-1/2” 36-1/8Page VENT TERMINAL CLEARANCESDETERMINING THE LOCATION FOR DV1000 DV1000 DIRECT VENT TERMINATION INSTALLATION INSTRUCTIONSPIPE INSTALLATION PRE-INSTALLATIONINFORMATIONOUTER 7” VENT PIPE INNER 4” FLUE PIPE FIGURE 8/ OPTIONAL REAR VENT TER CORNER TERMINATION WITH OPTIONAL REAR VENT9-1/2”WALL MINATION EXAMPLEMAXIMUM INSTALLATION MINIMUM INSTALLATIONVERTICAL TERMINATION CAP ASSEMBLY INSTALLATIONSDV1000 STANDARD VERTICAL CHASE TERMINATION 30FT MAXREMOVABLE INNER BOTTOM PAN ASSEMBLY Installation Items Needed INSTALLING GAS PIPING TO APPLIANCEGAS SUPPLY CONNECTION CHECK GAS TYPETest Pressures In Excess of 1/2 PSIG 3.5 kPa Pressure Testing Gas Supply Piping Systemance of the heater DV1000 LOG PLACEMENTWARNING Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury WHAT TO DO IF YOU SMELL GAS FOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONS TO TURN OFF GAS TO APPLIANCE WIRING DIAGRAM REPAIR PARTS SERVICINGCLEANING AND MAINTENANCE VENTURA ASSEMBLY Air Shutter Slot Opening BURNER PAN ASSEMBLYLOGS EMBERSOBSERVED PROBLEM TROUBLESHOOTINGPOSSIBLE CAUSE REMEDYBurner does not light after pilot is lit Diagram, pageMaintenance, page TROUBLESHOOTINGContinued Gas leak. See Warning statementSERVICING REPLACEMENT PARTSKEY# PART DESCRIPTIONPage ON/OFF/MANUALADDITIONAL REPLACEMENT PARTS WARRANTY WARRANTYPROCEDURE CONDITIONS AND EXCLUSIONSOTHER RIGHTS Page