Heat & Glo LifeStyle SL-550TV-D, SL-950TV-IPI-D Standing Pilot Ignition System Wiring, Ground to

IGNITION

INTERMITTENT

PILOT IGNITOR

I

INTERMITTENT PILOT IGNITOR

MODULE 3 VAC

S

TRANSFORMER 3V			WHITE
			ORG
			GROUND TO
PLUG-IN		BROWN	FIREPLACE CHASSIS
BLACK
	BROWN			GREEN
RED			ORG

BATTERY PACK

TRANSFORMER

3VAC

PLUG-IN

REMOTE RECEIVER

IGNITION MODULE 3 VAC

	WHITE
	ORG
BLACK	GROUND TO
	FIREPLACE CHASSIS
RED

TEMP SENSOR VALVE

THERMOSTAT WIRE ASSEMBLY

Figure 10.2 Intellifire Pilot Ignition (IPI) Wiring Diagram

TEMP SENSOR	JUMPER WIRE TO BROWN	ORG	GREEN
BATTERY PACK

VALVE

NOTE: 1. Ignition module, valve, pilot, and wall switch operate on 3 volts. 120 VAC is required at junction box unless equipped with battery back-up.

D. Standing Pilot Ignition System Wiring

This standing pilot ignition system wiring does not require a 110 VAC supply to operate.

It is recommended that a 110 VAC junction box be installed for use with a fan or remote control. (See Figure 10.4 for junction box wiring).

	WHITE
PILOT			PILOT
		PIEZO
THERMOCOUPLE			THERMOCOUPLE	WHITE
	RED	TEMP SENSOR
VALVE				RED
			VALVE
				TEMP SENSOR
				REMOTE
				RECEIVER
	THERMOSTAT WIRE ASSEMBLY
Figure 10.3	Standing Pilot Ignition Wiring Diagram
22		Heat & Glo • SL-550 / 750 / 950TV-D • 2053-985 Rev. J • 4/07