UK/IRL
4.5 Fitting the firebox
Points of attention for placement:
-If possible, first locate the appliance before assembling the flue.
-If this is not possible then always use an extendible pipe before connection onto the appliance.
1.Position the firebox in the fireplace opening. You can adjust the height with the 4 adjustable feet.
2Make the gas connection according to the instructions (also see gas connection, chapter 4.1).
3.Assemble the flue system onto the firebox (see chapter 5).
4.Check if applicable that the safety hatch seals the combustion chamber properly.
safety hatch
fig. 16
5.If necessary, place the DC convection system (also consult the instruction belonging to the DC construction set).
6.Isolate the firebox with a ceramic blanket (25 mm). Preferred choice for insulation is unbound insulation wool (at 1000 °C gives no smell).
7.Place the log set (see placing log set, chapter 4.4).
UK/IRL
4.5 Fitting the firebox (continuing)
ceramic blanket
ceramic blanket
| ceramic blanket |
ceramic | ceramic |
blanket | blanket |
fig. 17
8.Spread, the bags of embers (imitation ashes) provide with the appliance over the burner tray.
Attention! No embers on the grid end between the logs and the burner tray.
9.Before placing the glass; check the glass sealing rope is in good condition and makes an effective seal. Be sure that there are no fingerprints on the glass. It is not possible to remove those prints after you burn the appliance for a while (they are burnt in).
-Widescreen and Whisper; Place the glass in front of the appliance and fix it with the glass clamps. Replace the frame.
-Misty, Cadra Nova and Spectra Nova:
Place the door and fix it. Check on visual leakages around the door sealing.
10.Misty and widescreen: Fix the back and top or door frame (the back frame first).
24 |
|
|
| 25 |
|
|