Chateau™ Direct Vent Gas Fireplace
Hand-Held Remote Control Transmitter
Operating Instructions
Introduction
This transmitter operating range is approximately 20 feet (6 m). The transmitter operates on one of 1,048,576 security codes that are programmed into the transmitter at the factory; this transmitter operates on radio frequencies with non- directional signals. The receiver for this transmitter is built into the
Transmitter
Wall Clip
| Slot |
On H/L | �� |
Button |
|
Off | ON H/L |
Continuous | OFF/CONTINUOUS |
Pilot Button | PILOT BUTTON |
|
MODE
Mode Button
SET
Set Button 
Battery
Compartment
The transmitter operates on (2) 1.5V AAA batteries. It is recom- mended that ALKALINE batteries always be used for longer battery life and maximum operational performance.
Before using the transmitter, install the (2) AAA transmitter bat- teries into the battery compartment. (Use caution that batteries are installed in the proper direction.)
| FP1818 |
|
ON H/L | 1 | Key Settings |
OFF
Continuous
2
Pilot
MODE | 3 |
SET | 4 |
1. ON H/L | — Turns unit to ON and operates |
| the flame control HI or LO. |
2.OFF
CONTINUOUS PILOT — Shuts the unit OFF and acti-
|
| vates the continuous pilot on |
|
| feature. |
3. | MODE | — Changes unit from manual |
|
| mode to thermostatic mode. |
4. | SET | — Sets temperature in thermo |
|
| mode. |
LCD - Liquid Crystal Display
7
1
4
|
|
| 1. | DISPLAY | Indicates CURRENT room temperature. |
����� |
| 2 | 2. | ° F or ° C Indicates degrees Fahrenheit or Celsius | |
| 3. FLAME | Indicates burner/valve in operation | |||
|
| ||||
|
|
| 4. | ROOM | Indicates remote is in THERMOSTATIC mode |
|
| 3 5. | TEMP | Appears during manual operation | |
|
|
| 6. | SET | Appears while setting the desired tem- |
|
|
|
|
| perature in the thermostatic mode |
���� | ��� ���� | 5 | 7. | PILOT | Appears in the Continuous Pilot mode |
|
|
| |||
6
20011957 | 11 |