Chateau™ Direct Vent Gas Fireplace
�����
���� ���
Setting ° F / ° C Scale
The factory setting for temperature is ° F. To change this setting to ° C;
Press the ON H/L key and the OFF CONTINUOUS PILOT key on the transmitter at the same time. This will change from ° F to ° C. Follow this same procedure to change from ° C to ° F.
Manual Function
To operate the system in the manual “MODE” do the follow- ing:
���� 
ON - HI Flame Operation
Screen while de- pressing ON key
Screen while de- pressing OFF key
Screen after 3 sec- ond default
����
Screen after 3 sec- ond default
Press and release the ON H/L key. The appliance flame will come ON and display will show “HI”.
ON - LO Flame Operation
Press the ON H/L key. The appliance flame will modulate down to low flame and display will show “LO”.
Changing Flame Height
Press and hold the ON H/L key to raise or lower the flame height.
OFF Operation
Press the OFF Continuous Pilot key and the appliance flame will shut off. During this time the LCD screen will show “OF”. After 3 seconds, the LCD screen will default to display room temperature and the word “TEMP” will also show on the screen. (Flame icon will NOT appear on the LCD screen in OFF mode)
Screen whild de- pressing OFF key
���� 
����
Screen after de- pressing MODE key
����
Screen after 3 second default
��� ����
Screen while de- pressing SET key
Thermostat Function
Setting Desired Room Temperature
This remote control system can be thermostatically con- trolled when the transmitter is in the THERMOSTATIC mode. To set the MODE and DESIRED room temperature;
Press the MODE key until the LCD screen shows the word “ROOM”. The remote is now in the thermostatic mode.
NOTE: When the word “ROOM” is displayed on the screen, the transmitter is in the thermostatic mode.
12 | 20011957 |