Chateau™ Direct Vent Gas Fireplace
1.Ensure the four (4) screws that attach the fettle to the burner are secure.
2.Set the andirons in place by hooking the tabs on the back of the andirons over the webs of the fettle. (Fig. 43) Repeat process for and- irons on both sides of burner.
Figure 43 | Andirons |
Burner |
|
Housing | Fettle |
| |
| FP1803 |
Figure 44
Ember Material
5.Position the log pilot plumb- ing. (Fig. 45) Hold the log with the two (2) branches facing down and set it down over the pilot plumbing with the flat side of the log touching the side refractory.
Burner Tubes
3.Place the volcanic rock in front of each burner tube assembly and around the burner assembly as desired. (Fig. 44) Do not obstruct fresh air inlet with volcanic rock.
4.Place the ember material lightly, between each burner tube as- sembly and the burner housing, between the joined burner tubes and in front over the burner tube and on top of burner tube.
NOTE: The ember material must be built up from the burner tubes to the burner housing fronts in order for the burner tubes to light properly.
LG486
Lava Rock
Figure 45
Log Pilot Plumbing (F50)
LG493
30 | 20011957 |