INSTALLATION
LOCATING YOUR
OPTIONAL FAN INSTALLATION
EMERALD GAS STOVE
When selecting a location for your stove, en- sure that the clearances listed above are met as well as ensuring that there is adequate acces- sibility for servicing and proper operation.
A)Cross Corner
B)Room Divider
C)Island
D)Flat on Wall
E)Flat on Wall Corner
F)Flush with Wall/Alcove
For Vent Termination requirements, see page 10.
MANUFACTURED
MOBILE HOME
ADDITIONAL
REQUIREMENTS
1)Ensure that structural members are not cut or weakened during installation.
2)Ensure proper grounding using the #8 ground lug provided.
3)Appliance must be anchored to the floor with the supplied anchoring methods.
COMBUSTION AND VENTILATION AIR
The combustion air from this appliance is drawn from outside the building through the outer flue.
Extra provision for combustion air inside the room is not required.
Fan Kit Contains:
Qty. Description
1Fan Speed Controller with nut, and knob.
1Fan Assembly c/w green wire attached
1power cord
1Plastic locking grommet
1)Remove the Top Control Panel Assembly by removing the three screws. Diagram 1.
Diagram 1
2)Remove the nylon hole plug from the control panel.
3)Install the fan speed controller onto the control panel and secure with nut. Connect remaining wire harness wires to speed control. NOTE: Speed control wires must be in the down position when control panel is in place.
4)Push black knob onto speed control.
5)Remove the rear access panel on the back of the stove by removing the 6 screws. Install the fan onto pins as per diagram 2.
Diagram 2
NOTE: Do NOT damage, cut or remove the 3" aluminum air intake pipes.
Hint for pushing fan down onto pins - rub a bit of dish soap on the pins so the grom- mets will slide down more easily. Check to make sure the fan is seated properly on the pins - try to move the fan back and forth.
6)Push power cord through hole in the rear panel 14" - 16" and tie a loose knot in the cord on the inside to prevent the power cord from being pulled out. Diagram 2.
7)Install locking grommet to power cord and push through hole in the rear panel and give a 1/4 turn to secure.
NOTE: When running wires, keep them clear of valve assembly and tub- ing to avoid tangling of wires and valve.
NOTE: Be careful not to cut wires when passing through holes in the fire- box.
8)Run green ground wire from fan and con- nect to grounding lug.
9)Connect green power cord ground wire to grounding lug.
10)Run the neutral black wire from power cord and connect to fan motor.
11)Run the live black wire from power cord and connect to speed control wire.
12)Connect the white wire of the wire harness to the fan terminal.
NOTE: Pull excess wire next to fan to avoid excessive heat from the fire- box.
13)Ensure all wires are pulled away from firebox to avoid excessive heat and secure with
14)
NOTE: When power cord is plugged in, speed control is in the ON position and stove is burning, allow 10 - 15 minutes for the thermodisc (temperature switch) to activate and turn on the Fan automatically.
WARNING:
Electrical Grounding Instructions This appliance is equipped with a three pronged (grounding) plug for your protection against shock haz- ard and should be plugged directly into a properly grounded three- prong receptacle. Do not cut or re- move the grounding prong from this plug.
8 | Waterford |