
INSTALLATION
6)Remove and discard the 3 pressure regu- lator mounting screws (A), pressure reg- ulator tower (B) and diaphragm (C).
7)Insure that the rubber gasket (D) is properly positioned and install the new HI/LO pres- sure regulator assembly to the valve using the new screws (E) supplied with the kit. Tighten screws securely.
8)Pull off the pilot cap to expose the pilot orifice.
9)Unscrew the pilot orifice with the allen key and replace with the LP pilot orifice in the kit.
REDUCTION KIT TO LOWER BTU RATING FOR E65-1 GAS STOVE
THIS CONVERSION MUST BE DONE BY A
QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
Natural Gas Conversion Kit 260-920 Contains:
Qty.Part # | Description |
1
1
27,000 Btu"
1
Propane Conversion Kit 260-922 Contains:
Qty.Part # | Description | |
1 | Burner Orifice #52 (Propane) | |
1 | Decal "Converted to | |
|
| 29,000 Btu" |
1 | Instruction Sheet |
1)Shut off the gas supply.
2)Open the valve door and remove the con- trol panel.
Burner Orifice
10)Remove burner orifice with a 1/2" wrench and discard. Use a wrench to hold on to the elbow behind the orifice.
11)Reinstall new burner orifice LP stamped #50 and tighten.
12)Reverse steps 4) to 2).
13)Attach the Conversion label "This unit has been converted to Propane" on top of the Serial # decal. E63/E65: Part #175
14)Replace yellow "Natural Gas" label with red "Propane" label
15)Check for gas leaks.
16)Check inlet and outlet pressures.
17)Check operation of flame control.
18)Check for proper flame appearance and glow on logs.
26
3) Open the front door. Open the right side door and there is a cutout in the heat shield through which can be seen a wing nut threaded on to a stud attached to the front door. Loosen this nut by turning it counter- clockwise.
E63/E65 Conversion Decal:
The wing nut that holds the front door is accessible through the
Waterford