Weber 89796 manual Check for GAS Leaks, To Connect the hose to the cylinder

Page 10

10

GAS INSTRUCTIONS

 

 

Some LP tanks have differing top collar assembles. (The top collar is the metal protective ring around the valve.) One series of tanks mount with the valve facing front

(a). The other tanks mount with the valve facing away from the fuel scale (b). See Illustration.

The LP cylinder is installed inside the tank enclosure or tank cabinet, on the tank scale.

1)Turn the LP cylinder so the opening of the valve is either to the front, side or rear of the Weber® gas barbecue. Lift and hook the cylinder onto the fuel gauge.

2)Lift tank up into position on the tank scale.

3)Loosen the cylinder lock wing nut. Swing the cylinder lock down. Tighten the wing nut.

To Connect the hose to the cylinder:

4)Remove the plastic dust cover from the valve.

5)Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand- tighten only.

Note: This connection tightens clockwise and will not allow gas to flow unless the connection is tight. The connection requires tightening by hand only.

WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.

You will need: LP cylinder, a soap and water solution and a rag or brush to apply it.

6)Mix soap and water.

7)Turn on the cylinder valve.

8)Check for leaks by wetting the fi tting with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.

If there is a leak, turn off the gas and tighten the fi tting. Turn the gas back on and recheck with the soap and water solution.

If leak does not stop do not use the barbecue. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.

9)When leak checking is complete, turn gas supply off at the source and rinse connections with water.

(b)

(a)

CHECK FOR GAS LEAKS

After a period of nonuse, we recommend that you perform the following maintenance procedures for your safety.

WARNING: Check the hose before each use of the grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only Summit® authorized replacement hose. Contact the Summit® Built-In Customer Service at 1-800-446-1071.

•Inspect the burner for correct fl ame pattern. Clean if necessary, following the procedures outlined in the “General Maintenance” section of this manual.

•Check all gas fi ttings for leaks.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may loosen or damage a gas fitting.

WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution, and a rag or brush to apply it.

Note - Since some leak test solutions, including soap and water, may be slightly cor- rosive, all connections should be rinsed with water after checking for leaks.

Make sure side burner is OFF.

To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise.

WARNING: Do not ignite burners when leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

WWW.WEBER.COM®

Page 9 Page 11
Image 10
Page 9 Page 11
Contents #89796 Liquid Propane GAS Units only For Installation in Canada WARRANTY3Warranty OperatingLocating Your BUILT-IN Side Burner GAS InstructionsClearance from Combustible Surfaces or Structures Test Connections BUILT-IN GAS Line Locations General Construction DetailsMounting the Side Burner GAS Line Piping Typical Bulk Propane GAS Supply Installation17500 12000 Typical 20 LP Propane GAS Supply Installation Side Burner LP Supply Connections Connect GAS SupplyImportant LP Cylinder Information Connecting the Liquid Propane CylinderTest Connections Leak Check Preparation Check That ALL Burner Valves are OFFCheck for GAS Leaks To Connect the hose to the cylinderSafe Handling Tips for Liquid Propane GAS Cylinders OPERATING11Liquid Propane LP Cylinders Side Burner Lighting Instructions 12OPERATINGTo Extinguish Igniter MAINTENANCE13Manually Lighting the Side Burner Replace Igniter BatteriesProblem Check Cure Side Burner TroubleshootingSide Burner Maintenance Antes DE Poner a Funcionar LA Barbacoadegas Peligros Y Advertencias PeligroGarantía GARANTÍA17Para LA Instalación EN Canadá OperaciónUbicación DEL Quemador Lateral Empotrado Instrucciones Para EL GASSeparación DE Superficies O Estructuras Combustibles Pruebe LAS Conexiones Montaje DEL Quemador LateralEspecificaciones Generales Para LA Tubería Instalación Típica DE Suministro DE GAS Propano a GranelTubería DE LA Línea DE GAS Instrucciones Para EL GAS Conectar EL Suministro DE GAS Línea corrugada de gas al múltiplePreparativos Para LA Búsqueda DE Fugas Pruebe LAS ConexionesInformación Importante Sobre EL Cilindro DE Propano Licuado Conexión DEL Cilindro DE Propano LicuadoCompruebe QUE no Haya Fugas DE GAS Para conectar la manguera al cilindroOPERACIÓN25 Cilindros de propano licuadoInstrucciones Para Encender EL Quemador Lateral OperaciónPara Apagar Encendedor MANTENIMIENTO27Encendido Manual DEL Quemador Lateral Reemplace LAS Baterías DEL EncendedorProblema Revisar Remedio Resolución DE Problemas CON EL Quemador LateralMantenimiento DEL Quemador Lateral Mise EN Garde Mises EN Garde GARANTIE31 EN CAS D’INSTALLATION AU CanadaUtilisation Instructions Relatives AU GAZ Toutes les dimensions correspondent aux surfaces fi niesLocalisation DE Votre Bruleur Lateral Encastre Test DES Connexions Montage DU Bruleur LateralGeneralites Relatives AUX Canalisations Installation D’ARRIVEE DE GAZ Propane EN Vrac TypiqueCanalisations DE GAZ Test DES Raccords Raccordements D’ARRIVEE DE GAZ PL DU Bruleur Lateral Raccordement DE L’ARRIVEE DE GAZPreparation DE LA Detection DES Fuites Test DES RaccordsInformations IMP0ORTANTES Relatives a LA Bouteille DE PL Verifiez QUE Toutes LES Valves DES Bruleurs Sont FermeesDetection DES Fuites DE GAZ Pour connecter le tuyau à la bouteilleUTILISATION39 Bouteilles de gaz propane liquide PLInstructions Pour L’ALLUMAGE DU Bruleur Lateral 40UTILISATIONPour Eteindre Allumeur MAINTENANCE41Allumage Manuel DU Bruleur Lateral Remplacez LES Piles DE L’ALLUMEURMaintenance DU Bruleur Lateral Probleme Verification SolutionDepannage DU Bruleur Lateral Page WEBER-STEPHEN Products CO
Related manuals
Manual 44 pages 58 Kb

89796 specifications

The Weber 89796 is a distinguished model within Weber's range of high-quality grilling equipment, specifically tailored for both amateur and seasoned grill aficionados. This product draws on Weber’s renowned heritage of craftsmanship and innovation, making it a standout choice in the competitive grill market.

One of the primary features of the Weber 89796 is its robust construction. Made with premium materials, the grill ensures durability and longevity, standing up to the rigors of outdoor cooking. The stainless steel burners promise even heat distribution, eliminating hot spots that can lead to uneven cooking. This means that whether you're grilling steaks or vegetables, you can expect consistent results every time.

In terms of cooking space, the Weber 89796 offers ample room, allowing users to prepare food for family gatherings or larger outdoor events. The grill’s generous primary cooking area is complemented by a warming rack, which is perfect for keeping cooked foods warm or toasting buns. This expansive design enables users to multitask efficiently, cooking various dishes simultaneously.

The grill is also equipped with Weber's innovative Flavorizer Bars. These bars are designed to capture drippings from the meat, converting them into flavorful smoke that infuses the food with added taste. This unique feature not only enhances the flavor profile of grilled items but also helps reduce flare-ups, making the grilling process safer and more enjoyable.

Another significant technology integrated into the Weber 89796 is the grease management system, which simplifies cleanup and minimizes potential mess. This system directs grease away from the burners, reducing the risk of flare-ups and promoting a more manageable cooking environment.

Moreover, the grill features an electronic ignition system that allows for quick and reliable startup. With just a push of a button, users can ignite the grill with ease, ensuring that there's no need for matches or lighter fluid—a convenience that many modern grillers appreciate.

The Weber 89796 also comes with side tables that provide additional workspace for food prep and utensils. These tables enhance the overall functionality of the grill, making it versatile for a variety of outdoor cooking tasks.

In summary, the Weber 89796 embodies a perfect blend of robust construction, cutting-edge technologies, and user-focused features, making it a leading choice for grilling enthusiasts who demand quality and reliability in their outdoor cooking experiences. Whether for casual weekend gatherings or elaborate barbecues, this grill meets and exceeds the expectations of users, ensuring flavorful results every time.
Top Page Image Contents