–flammable, explosive dust (e.g. magnesium or alu- minium dust, etc.)
Appliance socket
Use the socket on the vacuum cleaner for the purpose defined in the operating instructions only.
Before plugging an appliance into the appliance socket:
1.Switch off the vacuum cleaner
2.Switch off the appliance to be connected.
CAUTION!
Follow the operating instruc- tions and safety instructions for appliances connected to the appliance socket.
Before starting the vacuum cleaner
Before starting the vacuum cleaner, check that it is in proper condition. Plugs and couplings in power cords must at least have splash protection.
Regularly check whether the power cord is damaged or shows signs of aging. Use the vacuum cleaner only if the power cord is intact (risk of electrocution in case of dam- age).
Never use the vacuum cleaner if the filter element is damaged.
During use
Do not damage the power cord (e.g. by moving over it or pulling or squeezing it).
Disconnect the power cord by pulling the plug only (do not pull or tug the power cord).
CAUTION!
Before sucking in liquids, remove the filter bag and check the performance of the floater (see section 7.2.3).
When sucking in liquids, always use a filter element or filter screen (for order number see section 9.5 "Accessories").
If foam appears, stop work immediately and empty the tank.
Maintenance and repair
CAUTION!
Always pull out the mains plug before cleaning and servicing the vacuum clea- ner.
Only carry out maintenance work described in the operating instructions.
CAUTION!
Use original Alto accessories and parts only. The use of other parts can adversely affect safety.
CAUTION!
Do not make technical modifi- cations to the vacuum cleaner. They could endanger your safety.
For further maintenance or repair work and the replace- ment of a faulty power cord please contact the Alto service department or an authorized Alto workshop.
Electrical connections
Check the rated voltage of the vacuum cleaner before con- necting it to the mains supply system. Ensure that the voltage shown on the rating plate corresponds to the voltage of the local mains power supply.
| ATTIX 8 GALLON |
ATTIX 8 GALLON AS/E | |
If you are using an extension | english |
| |
cord, use only those specified |
|
by the manufacturer or higher |
|
quality ones (see section 9.4 |
|
"Technical data"). |
|
It is recommended that the vacuum cleaner is connected via a residual current circuit breaker. This device stops the supply of electricity if the leakage current to earth ex- ceeds 30 mA for 30 ms or it has an earth tester circuit.
When using an extension cord, check the minimum cross- sections of the cable:
Cable length | Cross section |
m | mm2 |
up to 20 | 1.5 |
20 to 50 | 2.5 |
Arrange the electrical parts (sockets, plugs and couplings) and lay down the extension cord so that protection class is maintained.
CAUTION!
Never spray water on to the upper section of the vacuum cleaner: danger for persons, risk of
Observe the latest edition of the IEC regulations.
5