Nilfisk-ALTO SW 750 Use, Battery Check on a NEW Machine, Before Machine START-UP

Page 48

ENGLISH

USER MANUAL

USE

WARNING!

On some points of the machine there are some adhesive plates indicating:

–DANGER

–WARNING

–CAUTION

–NOTE

While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do not cover these plates for any reason and immediately replace them if they are damaged.

BATTERY CHECK ON A NEW MACHINE

The machine is supplied with a standard 12 V, 45 Ah GEL battery (which does not require maintenance).

BEFORE MACHINE START-UP

1.Make sure that there are no open doors/hoods and that the machine is in normal operating conditions.

2.If the machine has not been used after being transported, check that all the blocks used for the transportation have been removed.

3.Check that side and main broom are installed, otherwise install them (see the procedure in the Maintenance chapter).

STARTING AND STOPPING THE MACHINE

Starting the machine

1.Adjust the handlebar (6) to reach a comfortable position, by loosening the knobs (7). When the adjustment is completed, tighten the knobs.

2.To use the main broom only (14), turn the main switch (1) to “I”.

To use also the side broom (11), turn the main switch (1) to “II”, then lower the side broom by disengaging the lever (12) and by pushing it forward.

Check that the green warning light (2) (charged battery) turns on.

If the yellow or red warning light (3 or 4) turns on, turn the main switch (1) back to “0” and charge the batteries (see the procedure in the Maintenance chapter).

NOTE

The side broom (11) can be lifted and lowered even if it is turned on.

3.Start sweeping by grasping the handlebar (6) and pulling the drive control lever (5) gradually.

Stopping the machine

1.Release the drive control lever (5) to stop the drive system.

2.Turn off the vacuum system and the brooms, by turning the main switch (1) to “0”.

3.Lift the side broom (11) by pulling the lever (12) backwards and by engaging it to the fastener.

10

146 3080 000(1)2006-10 A

SW 750

Page 47 Page 49
Image 48
Page 47 Page 49
Contents Deutsch Français English Nederlands Sweeper Inhaltsverzeichnis EinleitungEinleitung AUSPACKEN/AUSLIEFERUNG Benutzte Symbole SicherheitAllgemeine Hinweise Betriebsanleitung Deutsch Maschinenbeschreibung Struktur UND Bedienelemente DER MaschineStruktur UND Bedienelemente DER Maschine Beschreibung ZUBEHÖRE/OPTIONEN Technische DatenAllgemein Werte Elektrische Teile WerteSchaltplan FarbencodesBetrieb Prüfung DER Batterien AN Einer Neuen MaschineVOR DEM Anlassen DER Maschine Maschinenanlassen UND -ABSTELLENMaschine in Betrieb Entleerung DES AbfallbehältersNach DER Maschinenbenutzung Lange Ausserdienststellung DER MaschineWartung Übersichtstabelle DER Planmässigen WartungPrüfung DES Ladegerätkabels Vorgang AllePrüfung UND Einstellung DER Seitenbesenhöhe AUSBAU/EINBAU DES SeitenbesensPrüfung UND Einstellung DER Hauptkehrwalzenhöhe AUSBAU/EINBAU DER Hauptkehrwalze S311357 Prüfung DER Flapshöhe UND Funktionsfähigkeit BatterieladungFehlersuche VerschrottungTable DES Matieres IntroductionIntroduction Deballage / Livraison Symboles Utilises SecuriteInstructions Generales Manuel Dutilisation Français Structure ET Commandes DE LA Machine Description DE LA MachineStructure ET Commandes DE LA Machine Description Accessoires / Options Caracteristiques TechniquesCaractéristiques générales Valeurs Parties électriques ValeursSchema Electrique Codes des couleursUtilisation Controle DES Batteries SUR UNE Machine NeuveAvant LA Mise EN Marche Mise EN Marche ET Arret DE LA MachineMachine AU Travail Vidange DU Conteneur DechetsApres Lutilisation DE LA Machine Inactivite Prolongee DE LA MachineEntretien Plan Recapitulatif Dentretien ProgrammeControle DU Cable DU Chargeur DE Batterie Procédure Toutes lesControle ET Reglage DE LA Hauteur DU Balai Lateral Depose / Repose DU Balai LateralControle ET Reglage DE LA Hauteur DU Balai Central Depose / Repose DU Balai Central S311359 Chargement DES Batteries Controle DE LA Hauteur ET DU Fonctionnement DES VoletsDepistage DES Pannes Mise EN DechargeTable of Contents Manual Purpose and Contents HOW to Keep this Manual Declaration of ConformityTarget Identification DataSpare Parts and Maintenance UNPACKING/DELIVERYOther Reference Manuals Changes and ImprovementsSafety SymbolsGeneral Instructions English Machine Description Machine Structure and ControlsMachine Structure and Controls Description ACCESSORIES/OPTIONS Technical DataGeneral Values Electrical components ValuesWiring Diagram Colour codeBattery Check on a NEW Machine USEBefore Machine START-UP Starting and Stopping the MachineMachine Operation Hopper EmptyingAfter Machine USE Machine Long InactivityMaintenance Scheduled Maintenance TableBattery Charger Cable Check Procedure Every 10 hours Every 50 hoursSide Broom Height Check and Adjustment Side Broom DISASSEMBLY/ASSEMBLYMain Broom Height Check Adjustment Main Broom DISASSEMBLY/ASSEMBLY S311357 S311358 S311359 Battery Charging Skirt Height and Operation CheckTroubleshooting ScrappingInhoudsopgave InleidingInleiding Verpakking VERWIJDEREN/AFLEVERING Gebruikte Symbolen VeiligheidAlgemene Instructies Gebruiksaanwijzing Nederlands Beschrijving VAN DE Machine Opbouw EN Bedieningselementen VAN DE MachineOpbouw EN Bedieningselementen VAN DE Machine Beschrijving Accessoires / Opties Technische EigenschappenAlgemeen Waarden Elektrische onderdelen WaardenElektrisch Schema KleurcoderingGebruik Controle VAN DE Accus OP EEN Nieuwe MachineVoor HET Starten VAN DE Machine DE Machine Starten EN StoppenMachine in Bedrijf DE Afvalcontainer LegenNA Gebruik VAN DE Machine Lange Periode VAN StilstandOnderhoudsschema Procedure Elke 10 uur Elke 50 uur Elke 200 uur Elke 400 uurOnderhoud Controle VAN DE Kabel VAN DE AcculaderDE Hoogte VAN DE Zijborstel Controleren EN Afstellen DEMONTAGE/MONTAGE VAN DE ZijborstelDE Hoogte VAN DE Hoofdborstel Controleren EN Afstellen DEMONTAGE/MONTAGE VAN DE Hoofdborstel Opmerking Controle VAN DE Hoogte EN Werking VAN DE Flaps Accu OpladenStoringen Lokaliseren Verwijdering

SW 750 specifications

The Nilfisk-ALTO SW 750 is a compact and highly efficient walk-behind scrubber dryer designed for a variety of indoor cleaning applications. Catering to the needs of small to medium-sized facilities, this machine excels in providing deep and effective cleaning while maximizing productivity. With its user-friendly design and advanced technologies, it is an ideal solution for maintenance in schools, shops, warehouses, and healthcare facilities.

One of the standout features of the Nilfisk-ALTO SW 750 is its robust construction and high maneuverability, which allows operators to navigate tight corners and congested areas with ease. The machine is equipped with a 12-volt battery that offers an impressive run time, ensuring that users can complete large cleaning tasks without interruption. The presence of an onboard charger adds to its convenience, allowing for quick and simple recharging between shifts.

The SW 750 utilizes an efficient scrub deck that combines a high-performance brush system with a powerful vacuum system. This dual-action feature ensures that dirt and debris are effectively removed from various surfaces, leaving floors spotless and dry. The machine’s adjustable brush pressure allows operators to customize the cleaning process based on the specific needs of different floor types, whether it be tile, concrete, or carpet.

Innovative technologies are integrated into the Nilfisk-ALTO SW 750 to enhance its cleaning capabilities. The machine includes the Ecoflex system, which provides users the option to adjust the amount of water and detergent used during cleaning. This not only helps in achieving excellent cleaning results but also promotes environmental sustainability by reducing chemical usage. Additionally, the machine features a Smart Key system, allowing for easy access control to prevent unauthorized use.

Another noteworthy characteristic of the SW 750 is its low noise operation, making it suitable for use in noise-sensitive environments. With a noise level significantly lower than many traditional scrubbers, it allows for cleaning operations to continue even during business hours without disturbing customers or staff.

Overall, the Nilfisk-ALTO SW 750 is a versatile and reliable cleaning solution tailored for efficient floor maintenance. Its combination of powerful cleaning performance, ease of use, and innovative technologies makes it an essential tool for professionals looking to maintain cleanliness in various settings. With its focus on user comfort and environmental responsibility, the SW 750 stands out as a leader in walk-behind scrubber technology.
Top Page Image Contents