Ariston 47-116-15 installation instructions Calculating the lengths of the pipes

	In calculating the lengths of the pipes, the
TWIN PIPE	maximum length “L” must also take into
SYSTEMS	consideration		the	values	for	the
	exhaust/air intake end terminals, as well
	as 90° elbows for coaxial systems.
	The C52 types must comply with the
	following requirements:
	1 -	The exhaust/ air intake pipes must
		have the same diameter of ø			80 mm.
	2 -	If elbows are to be inserted into the
		air intake and/or exhaust system, the
		calculation of the overall length must
		take into consideration the values for
		each elbow, see the FL U E				PI P E
		ACCESSORIES MANUAL.
	3 - The exhaust pipe must protrude by at
		least 0.5 m above the top of the roof
		in the event that it is located on the
		opposite side to the side with the air
		intake (this condition is not obligatory
		when the air intake and exhaust are
		located on the same side of the
		building).
FIG. 2.11	FU007A

2.10ROOM THERMOSTAT CONNECTION

To connect a room thermostat, it is necessary to:

1. - Open the control panel as indicated in section 3.3.

2.- Remove the link “A” from the terminal block on the reverse of the control panel.

3.- Insert the thermostat cable through the cable grommet and fasten it by means of the cable-clamp provided.

4.- Then connect the thermostat wires to the terminal block.

5.- If a remote time clock is to be fitted, disconnect the integral time clock from the P.C.B.

6.- Using a volt-free switching time clock, connect the switching wires from the time clock following points 1-4 above.

7.- If using an external time clock and room thermostat, these must be connected in series as points 1-7 above.

Note: Only a two-wire type room thermostat can be used.

An anti-frost device is built-in to the appliance’s electronic regulation system.

A

Fo016A

12

Fo017A