Desa LCR18NT, HDR18NT, LCR30NT, LCR26PT, HDR26PT, HDR30NT, HDR16PT, LCR16PT installation manual Safety

Page 3

Safety

Continued

Natural and Propane/LP Gas: Natural and Propane/LP gases are odorless. An odor-mak- ing agent is added to these gases. The odor helps you detect a gas leak. However, the odor added to the gas can fade. Gas may be present even though no odor exists.

Make certain you read and understand all warnings. Keep this manual for reference. It is your guide to safe and proper operation of this heater.

WARNING: Any change to this heater or its controls can be dangerous.

WARNING:Donotuseablow- er insert, heat exchanger insert or other accessory not approved for use with this heater.

Due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies.

Do not place clothing or other flammable material on or near the appliance. Never place any objects on the heater.

Surface of heater becomes very hot when running heater. Keep children and adults away from hot surface to avoid burns or clothing ignition. Heater will remain hot for a time after shut- down. Allow surface to cool before touching.

Carefully supervise young chil- dren when they are in the same room with heater.

Make sure grill guard is in place before running heater.

Keep the appliance area clear and free from combustible ma- terials, gasoline and other flam- mable vapors and liquids.

1.This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

2.Do not place propane/LP supply tank(s) inside any structure. Locate propane/LP supply tank(s) outdoors.

3.This heater shall not be installed in a bedroom or bathroom.

4.If you smell gas

Shut off gas supply

Do not try to light any appliance

Do not touch any electrical switch; do not use any phone in your building

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions

If you cannot reach your gas supplier, call the fire department

5.Always run heater with plaque control knob at the 1, 2, 3 or 4 locked positions. Never set control knob between locked positions. Poor combustion and higher levels of carbon monoxide may result.

6.This heater needs fresh, outside air ven- tilation to run properly. This heater has an Oxygen Depletion Sensing (ODS) safety shutoff system. The ODS shuts down the heater if not enough fresh air is available. See Air for Combustion and Ventilation, page 5.

7.Keep all air openings in front and bottom of heater clear and free of debris. This will insure enough air for proper combustion.

8.If heater shuts off, do not relight until you provide fresh, outside air. If heater keeps shutting off, have it serviced.

9.Do not run heater

where flammable liquids or vapors are used or stored

under dusty conditions

10.Do not use heater if any part has been under water. Immediately call a qualified service technician to inspect the room heater and to replace any part of the control system and any gas control which has been under water.

11.Turn off and unplug heater and let cool before servicing. Only a qualified service person should service and repair heater.

121255-01Awww.desatech.com

Image 3
Contents Models What to do if YOU Smell GASSafety Table of ContentsSafety Unpacking SafetyProduct Features Local CodesConfined and Unconfined Space Air For Combustion VentilationProviding Adequate Ventilation Unusually Tight ConstructionDetermining if You Have a Confined or Unconfined Space AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Ventilation AIRVentilation Air From Outdoors InstallationInstallation Items Check GAS TypeThermostat Sensing Bulb Locating HeaterInstalling Heater to Wall Placing Heater On Mounting Bracket Installing Bottom Mounting ScrewsMounting heater to floor With optional floor kit Attaching To Wall Anchor MethodConnecting to GAS Supply Mounting Base Feet to FloorTypical Inlet Pipe Diameters Checking GAS Connections Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa For Your Safety Read Before LightingPressure Testing Heater Gas Connections OperationLighting Instructions Do not try to light any applianceThermocouple Ignitor Electrode Pilot Burner Thermostat Control Manual Lighting ProcedureTo Select Heating Level To Turn OFF GAS To ApplianceBurner Flame Pattern CleaningInspecting Heater Pilot Flame PatternBurner Pilot Air Inlet Service HintsTechnical Service ODS/PILOT and BurnerObserved Problem Possible Cause Remedy TroubleshootingIs lit or shut off Cooling TroubleshootingReplace burner orifices Heaters. If noise is excesLP gas only Gas odor even when controlIng furniture polish, wax Not enough fresh air isAccessories SpecificationsCabinet body Models PartsKEY Burner Assembly Models Parts120630-03 099387-11 104818-04 099218-09 099056-25 099056-02 Parts Not Under Warranty Replacement PartsService Publications Parts Central Parts Under WarrantyWarranty Keep this WarrantyModel Serial No Date of Purchase Modelos QUÉ Hacer SI Percibe Olor a GASTabla de contenido Intoxicación con monóxido de carbono SeguridadSaque el calentador de la caja Códigos localesDesempaque Identificación del ProductoCaracterísticas del Producto Aire para combustión VentilaciónCómo Procurar LA Ventilación Adecuada Espacio confinado y no confinado Aire Para Combustión VentilaciónAire del interior de la construcción para ventilación Aire Para VentilaciónUbicación DEL Calentador InstalaciónVerifique EL Tipo DE GAS Artículos DE InstalaciónBulbo Sensor DE Termostato Instalación DEL Calentador EN LA ParedSoporte de montaje Calentador con 3 placas Desmontaje del panel anterior del calentadorMétodos para fijar el soporte de montaje a la pared Cómo marcar las ubicaciones de los tornillosMétodo de fijación a viga de pared Colocación del calentador en el soporte de montajeInstalación de los tornillos de montaje inferiores Conexión AL Suministro DE GAS Montaje de las patas de la base en el calentadorMontaje de las patas de la base en el piso Equipo Regulador Niple para De presión Tubería de Soporte del TipoGabinete del Unión Calentador Pulimentada Unión T Sin rosca Válvula de Buje Reductor Cierre delRepare todas las fugas inmediatamente Revisión DE LAS Conexiones DE GASRepare todas las fugas inmediatamente Válvula de Cierre del Equipo CerradaSuministro De propano Gas LP Válvula de cierre del equipo Funcionamiento POR SU SEGURIDAD, LEA Esto Antes DE Encender EL CalentadorInstrucciones DE Encendido Perilla de control Quemadores Para Seleccionar EL Nivel DE CalefacciónPerilla de control Botón del encendedor Termopar Electrodo del encendedor Quemador Del pilotoProcedimiento Para Encendido Manual Cómo Cerrar EL Suministro DE GAS AL AparatoControl CON Termostato FuncionamientoTermopar Del piloto Inspección del CalentadorPatrón DE LA Llama DEL Piloto Patrón DE LA Llama DEL CalentadorGabinete LimpiezaPiloto CON ODS Y Quemador Entrada de aire al piloto del quemadorProblema Observado Causa Posible Remedio Solución de problemasCausa Posible Remedio Solución DE Problemas ContinuaciónSolución DE Problemas Anotación de advertencia Servicio técnico EspecificacionesAccesorios Consejos para servicioModelos con gabinete PiezasAbrazadera de cable Conjunto de herrajesModelos con conjunto de quemador PiezasPiezas sin garantía Piezas de repuestoPublicaciones de Servicio Piezas con garantía121255-01 Rev. a 03/07 GarantíaGuarde Esta Garantía Modelo De serie Fecha de compra