Installation
Continued
LOCATING HEATER
This heater is designed to be mounted on a wall.
WARNING: Maintain the minimum clearances shown in Figure 4. If you can, provide greater clearances from floor, ceiling and joining wall.
You can locate heater on floor, away from a wall. An optional floor mounting stand is need- ed. Purchase the floor mounting stand from your dealer. See Accessories, page 21.
WARNING: Never install the heater
•in a bedroom or bathroom
•in a recreational vehicle
•where curtains, furniture, clothing or other flammable objects are less than 36" (91.5 cm) from the front, top or sides of the heater
•as a fireplace insert
•in high traffic areas
•in windy or drafty areas
CAUTION: If you install the heater in a home garage
•heater pilot and burner must be at least 18" (45.7 cm) above floor
•locate heater where moving vehicle will not hit it
CAUTION:Thisheatercreates warmaircurrents.Thesecurrents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operatingheaterwhereimpurities (such as, but not limited to, to- bacco smoke, aromatic candles, cleaning fluids, oil or kerosene lamps, etc.) in the air exist, may discolor walls or cause odors.
IMPORTANT:
For convenience and efficiency, install heater
•where there is easy access for operation, inspection and service
•in coldest part of room
If planning to use fan, locate heater near an electrical outlet.
CEILING |
|
|
10" (25.4 cm) |
| 36" |
|
| |
Minimum |
| (91.5 cm) |
From |
| Minimum |
Sides Of |
|
|
Heater |
|
|
|
| Right |
Left |
| Side |
|
| |
Side |
|
|
|
| Minimum To |
|
| Top Surface |
|
| Of Carpeting, |
36" | 2" (5.1 cm) Tile Or Other | |
| Combustible | |
(91.5 cm) | FLOOR | Material |
Figure 4 - Mounting Clearances As
Viewed From Front of Heater
THERMOSTAT SENSING BULB
The thermostat sensing bulb has been placed below the heater.
1.Place clamp on thermostat sensing bulb as shown in Figure 5. Clamp is provided in hardware package.
2.Snap clamp into upper mounting hole as shown in Figure 5. Mounting hole is located on lower left edge on back of heater. Make sure the thermostat sensing bulb is point- ing up.
Thermostat
Sensing
Bulb
Clamp
Figure 5 - Attaching Thermostat Sensing
Bulb
www.desatech.com121255-01A