Hearth and Home Technologies DV3732SBIL manual Appliance Setup

14 Appliance Setup

A. Remove Fixed Glass Assembly

See Section 14.G.

B. Remove the Shipping Materials

Remove shipping materials from inside or underneath the firebox.

C. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.

D. Accessories

Install approved accessories per instructions included with accessories. Contact your dealer for a list of ap- proved accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY Hearth & Home Technologies-approved optional acces- sories with this appliance. Using non-listed accessories could result in a safety hazard and will void the warranty.

RHEOSTAT
SWITCH	TEMPERATURE
	SENSOR
Figure 14.1 Fan Wiring with Rheostat

VARIABLE
SPEED SWITCH	JUNCTION BOX
TEMPERATURE
SENSOR SWITCH
BLUE
Figure 14.2 Detail of Fan Wiring with Rheostat

E. Lava Rock, Rockwool/Ember Placement

WARNING! Risk of Explosion! Follow ember placement instructions in manual. DO NOT place embers directly over burner ports. Replace ember material annually. Improperly placed embers interfere with proper burner operation.

Placing the Lava Rock

See Section 14F for Lava Rock placement instructions.

•Place lava rock on base pan. Do NOT place on burner top.

Placing the Ember Material

Ember material is shipped with this gas appliance. To place the ember material:

•Embers CANNOT be placed directly over ports. See Figure 14.4 for the only exception to this guideline. Care should be taken not to cover the lighting trail of ports (from back to front).

•When placing Glowing Embers® onto the burner care should be taken so that the ports are not covered. Place the dime-size ember pieces near the port holes in the burner top (see Figure 14.3). Failure to follow this pro- cedure will likely cause lighting and sooting problems.

•Some of the small port holes should be covered with ember material. See Figure 14.4 for detail.

•Save the remaining ember materials for use during appliance servicing. The embers provided should be enough for 3 to 5 applications.

Figure 14.3 Placement of Embers

PORT HOLES IN CIRCLED AREA

SHOULD BE COVERED WITH EMBER

MATERIAL. NO OTHER PORT HOLES

MAY COME INTO CONTACT WITH

EMBER MATERIAL.

Figure 14.4 Placement of Embers

Hearth & Home Technologies • DV3732SBI, DV3732SBIL • 2215-900 Rev. F • 9/12 59