Hearth and Home Technologies SL-750TRSFHHIPI Top Vent Horizontal Termination Two Elbows

Top Vent - Horizontal Termination - (continued)

Two Elbows

Note: Use SLP Series components only.

Note: There MUST be a 25% reduction in total H when using flex vent except when using the simple up and out installation (see Figure 5.3).

V Minimum			H Maximum
			SL-750TRSFHHIPI
90º Elbow			NOT ALLOWED
1/2 ft.*	152 mm	1 ft.		305 mm
1-1/2 ft.*	457 mm	2 ft.		610 mm
2-1/2 ft.*	762 mm	4 ft.		1.2 m
3-1/2 ft.	1.1 m	6 ft		1.8 m
4-1/2 ft.	1.4 m	14 ft.		4.3 m

H1 + H2 Maximum= 14 ft. (4.3 m)

V1 + H1 + H2 Maximum= 40 ft. (12.2 m)

* See warning below

WARNING *

Fire Risk.

• When using SLP-HRC-SS and SLP-HRC-ZC-

SStermination caps on top vented fireplaces, a one foot minimum vertical vent section is

required before installing first elbow.

•When using DVP-TB1 termination cap on top vented fireplaces, a three foot minimum vertical vent section is required before installing first elbow.

H2	V1
	H1

INSTALLED

HORIZONTALLY

Figure 7.5

26 Heat & Glo • SL-750TRSFHHIPI • 2156-900 Rev. F • 11/08