Viking DSOE305TSS, F20686 manual Self-Clean Cycle, Before starting the Self-Clean cycle

Product Care

Self-Clean Cycle

This oven features an automatic pyrolytic self-cleaning cycle. During this cycle, the oven reaches elevated temperatures in order to burn off soil and deposits. An integral smoke eliminator helps reduce odors associated with the soil burn off. A powder ash residue is left in the bottom of the oven after completion of the self-clean cycle. The door latch is automatically activated after selecting the self-clean setting. The latch ensures that the door cannot be opened while the oven interior is at clean temperatures.

Before starting the Self-Clean cycle:

1.Remove the oven racks, and any other items/utensils from the oven. The high heat generated during the cleaning cycle can discolor, warp, and damage these items. DO NOT use foil or liners in the oven. During the self-clean cycle, foil can burn or melt and damage the oven surface.

2.Wipe off any large spills from the oven bottom and sides. NEVER use oven cleaners inside a self-cleaning oven or on raised portions of the door.

3.Some areas of the oven must be cleaned by hand before the cycle begins. Soils in these areas will be baked on and very difficult to clean if not removed first. Clean the door up to the gasket, the door frame, and up to 2” (5.1 cm) inside the frame with detergent and hot water. Rinse thoroughly and dry.

WARNING

Make sureBURNall controlsOR areELECTRICAL“OFF” and ovenSHOCKis COOLHAZARDbefore cleaning. Failure to do so can result in burns or electrical shock.

CAUTION

DO NOT touch the exterior portions of the oven after self-cleaning cycle has begun, since some parts become extremely hot to the touch! During the first few times the self-cleaning feature is used, there may be some odor and smoking from the curing of the binder in the high- density insulation used in the oven. When the insulation is thoroughly cured, this odor will disappear. During subsequent self-cleaning cycles, you may sense an odor characteristic of high temperatures. Keep the kitchen well-vented during the self-cleaning cycle.

Self-Clean Cycle

To start the Self-Clean cycle: 1. Close the door completely. 2. Select “UPPER OVEN” or “LOWER

OVEN.” “SELECT MODE” will appear in the display for the selected oven.

3. Press “SELF CLEAN” from the oven function control panel.

4. Press “SET” or “ENTER.” At this time, “SELF CLEAN” will appear in the

display. The door lock indicator light

will remain on until the self-clean is completed or interrupted and the oven temperature drops to a safe temperature. A complete cycle takes approximately 3-1/2 hours, with an additional 30 minutes needed for the oven to cool down enough for the door latch to disengage.

Note: A whirring fan noise will be heard during the self-clean cycle and will continue to run for the 3-1/2 hour duration of the self-clean cycle.

5.The timer will count down from 4 hours. When the cycle is completed, press the “OFF” button for the selected oven.

6.When the oven has completely cooled, open the door and remove any ash from the oven surfaces with a damp cloth.

7.To cancel or interrupt the self-cleaning cycle, press the “OFF” button for the selected oven.

Product Care

60 61