Hoshizaki service manual Performance Data, FS-1022MLH-C with SRC-10H

Page 25

C. Performance Data

1. FS-1022MLH-C with SRC-10H

APPROXIMATE	Ambient				Water Temp. (F)
ICE PRODUCTION	Temp. (F)		50			70		90
PER 24 HR.	70	*832	378		803	365	784	356
	80	765	347		747	340	729	331
	90	712	324		*703	320	679	309
lbs./DAY ( l/day)	100	663	301		647	294	*600	273
APPROXIMATE ELECTRIC	70	1713	--		1717	--	1722	--
CONSUMPTION	80	1727	--		1731	--	1736	--
	90	1740	--		1745	--	1760	--
watts	100	1775	--		1789	--	1804	--
APPROXIMATE WATER	70	*100	377		96	364	94	356
CONSUMPTION PER 24 HR.	80	92	347		90	339	88	331
	90	85	323		*84	319	81	308
gal. / day (l/day)	100	80	301		78	293	*72	272
EVAPORATOR OUTLET TEMP.	70	*14	-10		14	-10	14	-10
F ( C)	80	14	-10		16	-9	16	-9
	90	16	-9		*16	-9	18	-8
	100	18	-8		18	-8	*18	-8
HEAD PRESSURE	70	*224	15.7		224	15.7	224	15.7
	80	233	16.4		233	16.4	233	16.4
	90	242	17.0		*242	17.0	242	17.0
PSIG (kg/sq.cmG)	100	279	19.6		279	19.6	*279	19.6
SUCTION PRESSURE	70	*29	2.0		29	2.0	29	2.0
PSIG (kg/sq.cmG)	80	30	2.1		30	2.1	30	2.1
	90	31	2.2		*31	2.2	31	2.2
	100	33	2.3		33	2.3	*33	2.3
HEAT OF REJECTION			1130	BTU/hr AT 90 F/WT 70 F
Note: We reserve the right to make changes in specifications					and	design	without	prior
notice.

25

Image 25

Contents SRC-10H Hoshizaki AMERICA, INC Contents Page Serious injury Important Safety InformationIndicates important information about the use and care UnitFor SRC FS-1022MLH-C Specifications IcemakerSRC-10H Condensing UnitIcemaker FS-1022MLH-C II. General Information ConstructionCondensing Unit a SRC-10H Icemaking Unit Sequence Cycles and Shutdown Sequence of OperationDrain Cycle Shutdown Cycle Sequence Flow Chart Control Board Sequence Flow Chart FS-1022MLH-C/SRC-10HControl Board Control Board Control Board LayoutNo. of Beeps Type of Alarm Reset Options Every 5 sec LED Lights and Audible Alarm SafetiesSequence Step Energized Components Min MaxS1 Dip Switch Setting Infrared Sensor Shutdown Delay Controls and AdjustmentsSeconds 1.6 minutes Factory Default S1 Dip Switch Setting Dispense Time S1 Dip Switch Setting Drain Timer IntervalBackup S1 Dip Switch MechanicalShutdown Delay Bin ControlIII Wiring Diagrams Safety Low-Pressure Switch Manual Reset Control Low-Pressure SwitchHigh-Pressure Switch FS-1022MLH-C with SRC-10H Performance DataDiagnostic Procedure IV. Service DiagnosisIce Production Check Page Page Page Control Board Check 5VDC Page Infrared Sensor Check Bin Control CheckMechanical Backup Bin Control Check Page Float Switch Check Float Switch Check and CleaningFloat Switch Cleaning Page No Ice Production Diagnostic ChartsNo Ice Production Possible Cause Startup No Ice Production Possible Cause Shutdown Service for Refrigerant Lines Removal and Replacement of ComponentsBrazing Refrigerant RecoveryEvacuation and Recharge R-404A Evaporator Assembly Components. See Fig Important Notes for Component ReplacementComponent Evaporator Assembly Upper Bearing Wear Check Removal and Replacement of CutterRemoval and Replacement of Auger Removal and Replacement of Extruding HeadRemoval and Replacement of Evaporator Page Removal and Replacement of Gear Motor 6b. Lower HousingPage Cleaning and Sanitizing Instructions VI. Cleaning and MaintenanceCleaning Solution Cleaning ProcedureFloat Switch Assembly Reservoir Cover Sanitizing Procedure Initial Sanitizing SolutionSanitizing Procedure Final Maintenance Frequency Area Task Maintenance ScheduleRemove the water from the icemaker water supply line Preparing the Icemaker for Long StorageDrain the evaporator