Installation Instructions
STEP 17 CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through 1" diameter inlet ports on the air gap, waste tee or disposer.
•Determine size of inlet port .
•Cut drain hose connector on the marked line, if required, to fit the inlet port .
Figure DD
Cutting Line
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 1" |
|
|
|
| 5/8" |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
IMPORTANT: Do not cut corrugated portion of hose
•If a longer drain hose is required, and you did not purchase 10' long GPF10L drain hose, add up to
Figure EE
Hose Clamp
Coupler
Hose Clamp
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
•Connect drain line to air gap, waste tee or disposer using the previously determined method.
•Secure the drain hose to the air gap, waste tee or disposer with clamps.
Method
Insert the drain hose into the air gap as shown.
Waste Tee Installation | Disposer Installation |
Figure FF
Method 2—High Drain Loop with the Waste Tee or Disposer
Route the drain hose of the dishwasher to a minimum height of 32" from the floor with the supplied hanger as shown.
Fasten to underside | Fasten to underside |
of countertop | of countertop |
| 32" |
| 32" |
18" | Min. | 18" | Min. |
|
| ||
Min. |
| Min. |
|
Waste Tee Installation | Disposer Installation |
Figure GG
IMPORTANT— One of the above methods must be used or dishwasher will not operate properly.
IMPORTANT— When |
|
|
|
|
|
|
|
|
|
| Remove |
| |
connecting drain line to disposer, |
|
|
|
| Hopper |
|
|
|
|
| |||
check to be sure that drain plug |
|
|
|
| Plug |
|
|
|
|
| |||
has been removed. DISHWASHER |
|
|
|
|
|
|
|
|
|
|
|
| |
WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. |
|
| ||||
TIP: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer.
13