Installation Instructions
STEP 18 CONNECT POWER SUPPLY
Skip this step if dishwasher is equipped with power cord.
Verify that power is turned off at the source.
•Locate junction box cover set aside in Step 1.
•Secure house wiring to the back of the junction box with a strain relief.
•Locate the three dishwasher wires, (white, black and green) with stripped ends. Insert dishwasher wires through the small hole in the junction box.
Connect
•Install the junction box cover. Check to be sure that wires are not pinched under the cover.
White
Black Ground 
Figure HH
WARNING
If house wiring is not
STEP 19 PRETEST CHECK LIST
Review this list after installing your dishwasher to avoid charges for a service call that is not covered by your warranty.
•Check to be sure power is OFF.
•Open door and remove all foam and paper packaging.
•Locate the Owner’s Manual set aside in Step 1.
•Read the Owner’s Manual for operating instructions.
•Check door opening and closing. If door does not open and close freely, check for proper routing of spring cable over pulley. If door drops or closes when released, adjust spring tension. See Step 3, Figure J.
•Check to be sure that wiring is secure under the dishwasher, not pinched or in contact with door springs or other components. See Step 9.
•Check door alignment with tub. If door hits tub, level dishwasher. See Step 14.
•Pull lower rack out about halfway. Check to be sure it does not roll back or forward on the door. If the rack moves, adjust leveling legs. See Step 14.
•Check door alignment with cabinet . If door hits cabinet, reposition or relevel dishwasher. See Steps 13, 14 and 15.
•Check that door spring does not contact water line, fill hose, wiring or other components. See Step 16.
•Verify water supply and drain lines are not kinked or in contact with other components. Contact with motor or dishwasher frame could cause noise.
See Steps 9 and 11.
•Turn on the sink hot water faucet and verify water temperature. Incoming water temperature must be between 120°F and 150°F. A minimum of 120°F temperature is required for best wash performance. See “Prepare Hot Water Line,” page 7.
•Add 2 quarts of water to the bottom of the dishwasher to lubricate the pump seal.
•Turn on water supply. Check for leaks. Tighten connections if needed.
•Remove protective film if present from the control panel and door.
•Avoid service call charges by ensuring there is an air gap or drain hose routed through the required 32" minimum height .
14