Cabinetry
A
Cutout for 30″(76.2 cm) Single Ovens only –
Below an Advantium or Microwave Oven or Between an Advantium or Microwave Oven and a Warming Drawer
For JTP30, JTP70, PT916, PT920, ZET938 models only.
Single 30″ (76.2 cm) Oven | Single 30″ (76.2 cm) Oven |
Below an Advantium or | Between an Advantium or |
Microwave Oven | Microwave Oven and a |
| Warming Drawer |
Per Advantium or Microwave Oven Requirement
2” (5.1 cm) Min.
Note: Install the oven only with specific models listed on the label located on top of the oven.
Per Advantium or Microwave Oven Requirement
Per Warming
Drawer
Requirement
2” (5.1 cm) Min.
2” (5.1 cm) Min.
NOTE: The middle rail separating the two openings may need to be larger than the 2” (5.1 cm) minimum shown. Always refer to the individual installation instructions packed with each product for specific requirements.
Combined Advantium or Microwave Oven and Wall Oven Installation:
When installed in combination with a single wall oven, use separate electrical junction boxes.
•Refer to the Advantium or microwave oven installation instructions for electrical requirements of that product.
•These connections must be made by a qualified electrician. All electrical connections must meet National Electrical Code or prevailing local codes.
NOTE: Additional clearances may be required. Check to be sure the oven supports above the Warming Drawer
do not obstruct the required interior depth and height. The middle rail separating the openings may need to be larger than the
2” (5.1 cm) minimum shown. Always refer to the individual installation instructions packed with each product for specific requirements.
Warming Drawer Combined with Advantium or Microwave Oven and Single Oven:
Install a separate 120V, 60Hz, properly grounded receptacle. See installation instructions packed with each product for specific requirements.
13