Installation Instructions
C
Securing the Oven in the Opening
C1 Sliding the Oven Into the Opening
a. Loop (do not tie) a 36” (91 cm) string around the conduit before the oven is slid into place. This will keep the conduit from falling behind the oven.
Pull out on string loop while pushing the oven into the cabinet
b. Lift oven into cabinet cutout using the oven opening as a grip. Carefully push against oven front frame. Do not push against outside edges.
c. As you slide the oven back, pull the string so that the conduit will lie on top of the oven in a natural loop.
d. When you are sure the conduit is out of the way, slide the oven 3/4 way back into the opening. Remove the string by pulling on one end of the loop.
C2 Drilling the Pilot Holes and Mounting the Oven
NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening as it will go and centered.
a. Drill through the mounting holes (top and bottom) of the side trim, for the #8 screws provided.
|
|
|
|
|
|
|
|
|
|
|
|
|
| The screws must |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
| Mounting |
| |||||||||
|
|
|
| Hole |
|
| be a minimum of | |||||||
|
|
|
| Locations |
|
| ||||||||
|
|
|
|
|
| 1/4” (6 mm) from | ||||||||
|
|
|
| (Hole |
|
|
| |||||||
|
|
|
| Locations |
| the front of the | ||||||||
|
|
|
| may vary) |
|
|
| cutout. | ||||||
|
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
WARNING: Mounting
screws must be used. Failure to do so could result in the oven
falling out of the cabinet causing serious injury.
b. Secure the oven to cabinet with screws provided.
NOTE: If the cabinet is particle board, you must use #8 x 3/4” particle board screws. These may be purchased at any hardware store.
16