GE r08654v-1 C3 Preparing for the Bottom Trim Installation, C4 Installing the Metal Bottom Trim

Installation Instructions

C3 Preparing for the Bottom Trim Installation

a. With oven installed, take the bottom trim and center it on the bottom front edge of the cabinet opening.

b. Using the trim	For 27″ (68.6 cm)
	models with Lower
as a template,
	Trim in Position,
mark the center	Mark (2) Mounting
	Hole Locations
of each slot
	here
(two total) where
the mounting holes
will be drilled.

c. Remove the trim.		*
	* Remove	For 30″ (76.2 cm)
		models with
	Lower Trim
d. Drill pilot holes into		Lower Trim in
	Before	Position, Mark
the center of each	Pre-drilling
		(2) Mounting
template mark.	Mounting	Hole Locations
	Holes
		here

C4 Installing the Metal

Bottom Trim

a. Place the bottom metal trim centered over the pre-drilled mounting holes. Tape the edges of the trim down to maintain the alignment.

b. Using two trim screws provided, secure the bottom trim to the bottom edge of the cabinet.

Side

Trim

Trim Screw Locations for 27″ (68.6 cm) models with

Lower Trim Side

Trim

Metal Lower Trim

Trim Screw Locations for 30″ (76.2 cm) models with

Lower Trim

IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service, the trim must be removed first or damage to the trim will occur.

17