Installation Instructions
WHAT YOU WILL NEED (CONT.)
•A GE water supply kit (containing tubing, shutoff valve and fittings listed below) is available at extra cost from your dealer or from Parts and Accessories, 800.626.2002.
•A cold water supply. The water pressure must be between 20 and 120 p.s.i.
•Power drill.
•1/2″ or adjustable wrench.
•Straight and Phillips blade screwdriver.
•Two 1/4 ″ outer diameter compression nuts and
2 ferrules
OR
•If you are using a GE SmartConnect™ Refrigerator Tubing kit, the necessary fittings are preassembled to the tubing.
•If your existing copper water line has a flared fitting at the end, you will need an adapter (available at plumbing supply stores) to connect the water line to the refrigerator OR you can cut off the flared fitting with a tube cutter and then use a compression fitting. Do not cut formed end from GE SmartConnect™ Refrigerator tubing.
•Shutoff valve to connect to the cold water line.
The shutoff valve should have a water inlet with a minimum inside diameter of 5/32″ at the point of connection to the COLD WATER LINE.
Install the shutoff valve on the nearest frequently used drinking water line.
1SHUT OFF THE MAIN WATER SUPPLY
Turn on the nearest faucet long enough to clear the line of water.
2CHOOSE THE VALVE LOCATION
Choose a location for the valve that is easily accessible. It is best to connect into the side of a vertical water pipe. When it is necessary to connect into a horizontal water pipe, make the connection to the top or side, rather than at the bottom,
to avoid drawing off any sediment from the water pipe.
3DRILL THE HOLE FOR THE VALVE
Drill a 1/4″ hole in the water pipe (even if using a
Take care not to allow water to drain into the drill. Failure to drill a 1/4″ hole may result in reduced ice production or smaller cubes.
15