About crisper removal, Safety, Support

About crisper removal.

www.GEAppliances.com

Not all features are on all models.

Safety

Crisper Removal

To Remove:

These drawers can be removed easily by lifting up slightly while pulling the drawer past the stop location.

When the door cannot be fully opened, remove the drawer farthest from the door first. Make sure the drawer closest to the door is fully closed. There is a latch at the front of the center slide rail. Push down on the latch and slide the center slide rail, to which the drawer is attached, away from the door. Remove the drawer.

Instructions Operating Instructions

About the automatic icemaker.

A newly-installed refrigerator may take 12–24 hours to begin making ice.

Installation

Power Switch		Automatic Icemaker (on some models)
Power Switch
	Icemaker	The icemaker will produce seven cubes
		per cycle—approximately 100–130 cubes
		in a 24-hour period, depending on freezer
		compartment temperature, room
		temperature, number of door openings
		and other use conditions.
Green	Feeler Arm	If the refrigerator is operated before the
Power Light	Feeler Arm	water connection is made to the icemaker,
		water connection is made to the icemaker,
		set the power switch to O (off).
		When the refrigerator has been connected
		to the water supply, set the power switch to
		I (on). The green light will come on.
		The icemaker will fill with water when it
		cools to 15°F. A newly-installed refrigerator
		may take 12 to 24 hours to begin making
		ice cubes.
		You will hear a buzzing sound each time
		the icemaker fills with water.
		Throw away the first few batches of ice to
		allow the water line to clear.

Be sure nothing interferes with the sweep of the feeler arm.

When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.

It is normal for several cubes to be joined together.

If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink.

If ice cubes get stuck in the icemaker, the green power light will blink. To correct this, set the power switch to O (off) and remove the cubes. Set the power switch to I (on) to restart the icemaker.

After the icemaker has been turned on again, there will be a delay of about 45 minutes before the icemaker resumes operations.

NOTE: In homes with lower-than-average water pressure, you may hear the icemaker cycle multiple times when making one batch of ice.

Instructions Troubleshooting Tips Consumer

Icemaker Accessory Kit

If your refrigerator did not come already	Check the back of the refrigerator for
equipped with an automatic icemaker,	the specific icemaker kit needed for
an icemaker accessory kit is available at	your model.
extra cost.	9
	9