![](/images/new-backgrounds/1039455/3945519x1.webp)
XP MZ5/37
General information Power supply | Connections | |||
|
|
|
|
|
English
Speaker connections
The speaker terminals are
R | L | R |
AUX in |
|
|
8 Ω | speakers |
|
LEFT | LEFT |
– | + |
RIGHT | RIGHT |
– | + |
Safety information
•Place the set on a hard and flat surface so that the system does not tilt. Make sure there is adequate ventilation to prevent the system from overheating.
•The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.
•Connect the marked red wire to the red terminal and the unmarked wire the black terminal.
•When headphones are inserted into the headphone jack the speakers are disconnected.
AUX IN
You can connect the audio left and right OUT terminals of another sound system, e.g. CDR, cassette recorder to the corresponding left and right AUX IN terminals at the rear of the set.
•Use the
Power supply | • For playback of a connected |
| |
1 Check if the power voltage, as shown on the | the |
type plate located on the bottom of the |
|
set, corresponds to your local power voltage. If it |
|
does not, consult your dealer or service center. |
|
2 If your set is equipped with a voltage selector on |
|
the bottom of the set, adjust the selector so that |
|
it matches with the local power voltage. |
|
3 Connect the power plug to the wall outlet and |
|
the set is now ready for use. |
|
➜ The clock display ··· : ··· flashes. |
|
4 To disconnect the set from the power |
|
completely, remove the plug from the wall outlet. |
|
|
|
As a |
|
switches to standby if: |
|
– 15 minutes after a CD has reached the end |
|
and no control is operated. |
|
– after more than 24 hours no controls are |
|
operated. |
|
10