![](/images/new-backgrounds/1039455/3945533x1.webp)
XP MZ5/37
Troubleshooting
WARNING
Do not open the set as there is a risk of electric shock! Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty
If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
Problem | Solution |
|
|
No sound /power | – Volume not adjusted. Adjust the VOLUME. |
| – Headphones connected. Disconnect headphones. |
| – AC mains not securely plugged to wall outlet. Plug in properly. |
|
|
No reaction to controls | – Electrostatic discharge. |
| Disconnect the unit from the AC power supply reconnect after |
| a few seconds. |
|
|
TIMER/SLEEPER | – Clock time not set. Set the correct clock time. |
does not work |
|
|
|
Severe radio hum or noise | – Electrical interference set too close to TV,VCR or computer. |
| Increase the distance. |
|
|
Poor radio reception | – Weak radio signal. |
| FM: Direct the FM antennawire for optimum reception. |
|
|
NO DISC or | – CD badly scratched or dirty. Replace/ clean CD, see Maintenance. |
DISC NOTREADABLE | – |
indication | – Laser lens steamed up. Wait until lens has cleared. |
|
|
The CD skips tracks | – CD damaged or dirty. Replace or clean CD. |
| – SHUFFLE or PROGRAM is active. Switch off SHUFFLE/ PROGRAM. |
|
|
Remote control does | – Batteries exhausted. Insert fresh batteries |
not function properly | – Batteries incorrectly inserted. Insert the batteries correctly. |
| – Distance/ angle between the set too large. |
| Reduce the distance/ angle. |
|
|
English
17