In the programmed edit recording function the tracks can be programmed while checking the remaining time on each side of the tape as the tracks are programmed.
1 Insert the tape into Deck 1.
Insert the tape with the side to be recorded on first facing out from the unit, and wind up the tape with <.
2Press CD and load the disc(s).
3Press CD EDIT/CHECK twice while pressing
SHIFT on the remote control.
“EDIT”and “PRGM”are displayed.
PRGMEDIT
●When “AI” is displayed, press CD EDIT/CHECK while pressing SHIFT again.
4 Press numbered buttons on the remote control to designate the tape length.
10 to 99 minutes can be specified.
. <M, - | or MULTI JOG | are also available to designate |
the tape | length. | Tape side A (front side) |
Tape length |
Maximum recording time for side A
5 Press one of DISC DIRECT PLAY
Then, press numbered buttons
To select disc 4 or 5 from the remote control, press DISC
DIRECT PLAY 4 or 5 while pressing SHIFT.
Example: To select the 10th track of disc 2, press DISC DIRECT PLAY 2, then press +10 and O.
| Remaining | Programmed |
Selected track number | time on side A | track numbers |
Prog;am number
6Repeat step 5 for the rest of the tracks for side A.
A track whose playing time is longer than the remaining time cannot be programmed.
7Press CD EDIT/CHECK while pressing SHIFT on the remote control to select side B and program the tracks for side B.
Tape side B (reverse side)
8Press CD EDIT/CHECK while pressing SHIFT to select side A and press ● on Deck 1.
~flashes for 10 seconds, and then CD play and recording of edited tracks for the first side start simultaneously. When the end of the tape is reached, Deck 1 enters the recording stop mode. After entering the recording stop mode, go to step 9.
9Press CD EDIT/CHECK while pressing SHIFT on the remote control for recording of the second side.
“B”is displayed.
10 Turn over the tape in Deck 1 and press @to start recording.
Recording starts.
To stop recording
Press ■/A on Deck 1. Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press < or M- repeatedly.
Track number Programmed track numbers
Disc ~umber Progra’m number
To change the program of each side
Press CD EDIT/CHECK while pressing SHIFT on the remote control to select side A or B, and press ■CLEAR to clear the program on the selected side. Then program tracks again.
To clear the edit program
Press ■CLEAR twice in stop mode so that “EDIT”disappears on Ithe display.
mm
●Recording is inhibited if the erasure prevention tab for the side
of the tape facing out from the unit is broken off.
s Up to 30 tracks can be programmed from any of the inserted discs.
. “FULL” is displayed if you attempt to program more than 30 tracks.