Aiwa Z-L31 manual Tuner Section, Cassette Deck Section, CD Player Section

Page 22

Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit.

To clean the cabinet

Use a soft and dry cloth.

If the surfaces are extremely dirty, use a soft cloth lightly moistened with mild detergent solution. DO not use strong solvents, such as alcohol, benzine or thinner as these could damage the finish of the unit.

To clean the tape heads

When the tape heads are dirty;

-high frequency sound is not emitted

-the sound is not adequately high

-the sound is off-balance

-the tape cannot be erased

-the tape cannot be recorded on

After every 10 hours of use, clean the tape heads with a head cleaning cassette.

Refer to the instructions of the cleaning cassette for details.

To dernagnetuze the tape heads

The tape heads may become magnetized after long-term use. This may narrow the output range of recorded tapes and increase noise.

After every 20 to 30 hours of use, demagnetize the tape heads with a separately sold demagnetizing cassette.

Refer to the instructions of the demagnetizing cassette for details.

Care of discs

“When a disc becomes dirty, wipe the disc from the center out with a cleaning cloth.

. After playing a disc, store the disc in its case. Do not leave the disc in places that are hot or humid.

Care of tapes

●Store tapes in their cases after use.

●Do not leave tapes near magnets, motors, television sets, or any source of magnetism. This will downgrade the sound quality and cause noise.

●Do not expose tapes to direct sunlight, or leave them in a car parked in direct sunlight.

If the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL

There is no sound,

●Is the AC cord connected properly?

●Is there a bad connection? (+ page 4)

●There may be a short circuit in the speaker terminals.

-+ Disconnect the AC cord, then correct the speaker connections.

●Was an incorrect function button pressed?

Sound is emitted from one speaker only.

●Is the other speaker disconnected?

An erroneous display or a malfunction occurs.

+Reset the unit as stated below.

TUNER SECTION

There is constant, wave-like static,

●Is the antenna connected properly? (+ page 5)

●Is the signal weak?

+ Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion?

+Change the orientation of the antenna.

+Move the unit away from other electrical appliances.

CASSETTE DECK SECTION

The tape does not run.

●Is the deck in pause mode? (+ page 11)

The sound is off-balance or not adequately high.

●Is the playback head dirty? (+ page 22)

Recording is not possible.

●Is the erasure prevention tab on the tape broken off? (+ page 15)

●Is the recording head dirty? (+ page 22)

Erasure is not possible.

●is the erasure head dirty? (+ page 22)

●Is a metal tape being used?

High frequency sound is not emitted.

●Is the recording/playback head dirty? (+ page 22)

CD PLAYER SECTION

The CD player does not play.

●Is the disc correctly placed? (+ page 12)

●Is the disc dirty? (+ page 22)

●Is the lens affected by condensation?

+Wait approximately one hour and try again.

To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press POWER to turn off the power.

2Press POWER to turn the power back on while pressing ❑ CLEAR. Everything stored in memory after purchase is

canceled.

If the power cannot be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord, and connect it again. Then carry out step 2.

22 ENGLISH

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Mil!i AC power cord InstallationElectric Power Owner’s record ~Manual Tuning Presetting Stations Connections Remote Control Before OperationAudio Adjustments Setting the ClockBefore connecting the AC cord Check your system and accessoriesRight speaker Connect the right speaker to the main unit Connect the supplied antenhas Connecting AN Outdoor AntennaConnect the stereo turntable to the main unit Connect the AC cord to an AC outletTo use Function on the remote control BUILT-IN Subwoofer System Setting Power Economizing ModeChannel MULTI-AMPLIFIER System Press ECCTo play the game Demo To start or end game Demo when the clock is setTo reset the game Demo To change the probability of equalizing the three numbersSuper T-BASS System Volume ControlPress GEQ repeatedly to select the equalization mode Press T-BASSTo change the AM tuning interval To select a band with the remote controlWhen an FM stereo broadcast contains noise PressTUNER/BAND to select the FM or AM bandPressTAPE, then press WA to open the cassette holder Preset Number TuningRepeat steps 1 Press to start DlawTo rXav one disc only, press one of Disc Direct Play 1 Selecting a track with the remote controlPress E To search for a particular point during playback, keep +On a CD can be %ess to start playbackPress one of Disc Direct Play 1-5 to select a disc Press numbered buttons O-9 and +1 O to program a trackTo erase a recording Sound adjustment during recordingPress cm Deck 1 to start recording Press on Deck 1 to start recording on the first side Insert the tape into DeckControl to designate the tape length To add tracks from other discs to the edit programTo check the order of the programmed track numbers Repeat for the rest of the tracks for side aTurn over the tape in Deck 1 and press @to start recording To change the program of each sidePress To view the clock when another display is in the displayTo cancel the sleep timer Press Enter orPress Timer to display @l and ! Play Adjust the volumePress Power to turn off the power Get ready for the Tape function or the timer recordingPress Phono on the main unit Adjust the volume to minimumAdjust the volume according to your preference Play the turntableCD Digital OUT Optical LPress VIDEO/AUXLPlay the connected equipment VIDEO/AUXCassette Deck Section Tuner SectionCD Player Section Copyright Speakers High FreqSpeakers LOW Freq NcteAP!!!!!RA SX-WZL60Conexiones Control Remoto Antes DE LA Operacion Cuidadosy Mantenimiento Gjia Para LA Solucion DE ProblemasNo Trate DE Reparar LA Unidad Usted Mismo Ajustes DE Audio Ecualizador GraficoImportante Conecte el altavoz derecho a la unidad principalConecte el altavoz izquierdo a la unidad principal Speakers High Freq RConecte Ias antenas suministradas Conecte el plato giradiscos estereo a la unidad principalConecte el cable de alimentacion de CA a una Para utilizar Shift del control remoto Insertion de as pilasCuando reemplazar Ias pilas Para utilizar Function del control remotoCanales Puesta DEL Modo DE Ahorro DE EnergiaSistema DE Super Woofer Incorporado Para rewoducir la demostracion Demostracion DE JuegoPara reanudar la demostracion del juego Para seleccionar con el control remoto Para cancelar el modo seleccionadoPulse T-BASS Utilization de auricularesPara buscar rapidamente una emisora busqueda Automatic PulseTUNER/BAND para seleccionar la banda de FM ode AMPara seleccionar una banda con el control remoto Cuando una radiodifusion estereo por FM tenga ruidoPulse h para iniciar la reproduction Repita Ios pasos 1 yPulse TAPE, Iuego pulse /4 Para abrir el Portacasete Para bcmrar una emisora preajustadaTodos Ios discos de la bandeia, pulse Botones Disc Direct PlayPulse CD Blank Skip del control remoto Reproduction CON Salto DE Secciones EN BlancoPulse para iniciar la reproduction Para borrar el programa Para comprobar el programaPara aiiadir canciones al programa Para grabar parte de un disco compacto Inserte la cinta que vaya a grabar en la platinaPulse O de la platina 1 para iniciar la grabacion Para borrar una grabacionPara eliminar el programa editado Inserte la cinta en la platinaPara parar la grabacion en la mitad ClosePara detener la grabacion Una cancion CUYOtiempo De reproduccibn sea superior aPara cambiar el programa de cada cara Para cambiar al modo de 24 horas PulsePulse Enter o Il Si parpadea la visualization del relojPulse Power para desconectar la alimentacion Pulse Timer para visualizer@ y H PlayAjuste el volumen Prepare la fuentePara comprobar el ajuste del temporizador Ajuste el volumen al minimoAjuste el volumen segun sus preferencias Pulse Phono de la unidad principalCD Digital OUT Pulse VIDEO/AUXCuando no se utilice la toma CD Digital OUT Optical CD Digital OUT OpticalPara desmagnetizar Ias cabezas magnetofonicas Para Iimpiar la cajaPara Iimpiar Ias cabezas magnetofonicas Cuidado de Ios discosDerechos DE Autor Reference de I’utilisateur CX-ZL31Enregistrement Precautions a Prendre ET EntretienEntretien Enregistrement Avec Montage ET Calcul DU TempsRaccordez I’enceinte gauche a I’appareil principal Raccordez I’enceinte droite a I’appareil principalAvant de brancher Ie cordon d’alimentation secteur Speakers High Freq RRaccordement D’UNE Antenne Exterieure Mise en place des piles Pour utiliser Shift de la telecommandePour utiliser Function de la tt$lecommande Quand remplacer les pilesAppuyez sur Enter clans Ies quatre secondes Systeme a HAUT-PARLEUR Infragrave IntegreAppuyez sur ECO Consornmation en attentePour jouer Ie jeu de demonstration Pour reinitialiser Ie jeuUtilisation d’un casque Pour selectionner avec la telecommandeAppuyez sur T-BASS ROCK- POP CLASSIC- GEQ OFFAppuyez sur TUNER/BAND pour selectionner la gamme FM ou AM Quand une emission FM stereo contient des parasitesAppuyez sur Tape puis sulr WA pour ouvrir Ie porte-cassette Accord PAR Numero DE PrereglageRep6tez Ies etapes 1 et Appuyez sur pour commencer la lecturePour arr&er la lecture, appuyez sur Selection d’une plage avec la telecommandeLecture DE Disques Pour rechercher un point particulier pendant la lectureAppuyez sur CD Blank Skip de I’appareil principal Lecture Avec Saut Dies BlancsAppuyez sur b pour demarrer la lecture Repetez Ies etapes Et 3 pour ’autresInserez la cassette a enregistrer clans la platine Appuyez sur de la platine 1 pour commencer ’enregistrementSeconde EDIT/CHECK en maintenant Shift enfonceePremiere Pour arr6ter I’enregistrementInserez la cassette clans la platine Repetez I’etape 5 pour Ie reste des plages de la face aAppuyez sur Appuyez sur Enter ouAppuyez sur Timer pour afficher @ et U Play Reglez Ie volumeAppuyez Sur Power Pour mettre I’appareil Hors Tension Preparez La sourceAppuyez sur la touche Phono de I’appareil principal Reglez Ie volume au minimumReglez Ie volume selon vos preferences Lancez la lecture du disque sur Ie tourne-disqueCD Digital OUT Optical VIDEO/AUX Appuyez sur VIDEO/AUXMettez I’appareil raccorde en marche Quiiild la prise CD Digital OUT Optical n’est pas utiliseeSection Tuner Pour r6initialiser I’appareilGeneralities Section Platine a CassetteDIN Audio DINAudio Speakers High FreqGEQ Graphic equalizer @ Deck 11.19

Z-L31 specifications

The Aiwa Z-L31 is a remarkable piece of technology that encapsulates the essence of smart audio devices with its advanced features and high-quality sound output. Designed with a sleek and minimalist aesthetic, this model has captured the attention of audiophiles and casual listeners alike, thanks to its modern design and impressive performance metrics.

One of the standout features of the Aiwa Z-L31 is its high-fidelity audio capabilities. It employs a powerful digital signal processor (DSP) that ensures distortion-free sound reproduction, allowing listeners to experience their favorite tracks as the artists intended. The unit supports various audio formats, making it versatile for music lovers who enjoy everything from classic rock to modern pop.

The Aiwa Z-L31 also integrates advanced connectivity options. With built-in Bluetooth technology, users can effortlessly stream music from their smartphones, tablets, or computers. Additionally, the device features a USB port, enabling direct playback from thumb drives, as well as an auxiliary input for connecting external devices. This flexibility ensures that users can enjoy their music library in numerous ways.

Battery life is another significant attribute of the Aiwa Z-L31. Enhanced with efficient energy management technologies, it offers long playback times on a single charge. This ensures that you can enjoy uninterrupted music sessions during gatherings, workouts, or while commuting, without the constant need for recharging.

Furthermore, the Aiwa Z-L31 boasts an intuitive user interface, making it easy for anyone to operate. The controls are intuitively laid out, allowing users to adjust volume, change tracks, and switch modes seamlessly. The clear display provides essential information, such as track details and connectivity status, enhancing the overall user experience.

Sound quality is further enhanced by the incorporation of advanced sound processing technologies, including equalization options that let users customize their audio experience according to personal preferences. Whether you prefer deep bass or crisp treble, the Aiwa Z-L31 can be tailored to suit individual tastes.

In summary, the Aiwa Z-L31 distinguishes itself as a premium audio device, combining sleek design, high-fidelity sound, and user-friendly features. Its advanced technologies, including Bluetooth connectivity, versatile audio support, and impressive battery life, make it a compelling choice for anyone in search of a reliable and stylish audio solution.
Top Page Image Contents