Cannon 10548G MK2, 10545G MK2 Care and Cleaning, Main Oven Heat Clean Linings, Oven Doors

Page 25

CARE AND CLEANING

Switch off the electricity supply and allow to cool before cleaning the cooker.

Clean the cooker regularly and wipe up spills soon after they occur to prevent them from becoming burnt on. Never use biological washing powder, caustic cleaners, harsh abrasives, scouring pads, steam cleaners, aerosol cleaners or oven chemical cleaners of any kind.

Before moving your cooker ensure that it is cool and note that it is heavy (approximately 70 kg 155 lbs), so you may require assistance. To move the cooker forward, open the top oven/grill door and with both hands positioned under the roof of the compartment, lift and pull forward. Replace by pushing the cooker backwards. Check that the cooker is level. Take care to ensure that any floor covering is not damaged.

MAIN OVEN HEAT CLEAN LININGS

The oven roof, back and side linings are coated with a special enamel which has a continuous cleaning action. The higher the oven temperature the more effective the action. In most cases this cleaning operation will proceed during normal cooking. However, if roasting is done frequently, or high temperatures are not used regularly, it may be necessary to run the oven empty at Mark 8 for about two hours.

It should not normally be necessary to clean the linings with water, but if desired, wipe them over with a soapy cloth, followed by a wipe with a damp clean cloth.

OVEN DOORS

The inner glass panel can be removed for easy cleaning. Unscrew the two screws securing the glass panel, taking care not to allow the glass to fall. The glass panel can then be washed at the sink. Refit the glass panel according to the instruction on it. Warning: The oven must not be operated with the inner glass panel removed.

REPLACEMENT OF OVEN LIGHT BULB

CAUTION: DISCONNECT THE APPLIANCE FROM THE ELECTRICITY SUPPLY BEFORE REPLACING THE LAMP TO AVOID THE POSSIBILITY OF AN ELECTRIC SHOCK Light bulbs are not covered by the manufacturer’s guarantee.

A new 15W, 300oC rated SES bulb can be obtained from your cooker supplier or any major electrical retailer.

1.Remove the shelves from the oven.

2.Unscrew the lens using a thick cloth to protect your fingers in the unlikely event of a lens fracture.

3.Unscrew bulb.

4.Fit new bulb and refit lens.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Chester Contents Introduction For Your Safety Leave Unattended While Cooking Automatic Cooking Automatic CookingGuidance on Automatic Cooking Clockface Timer OperationSetting the Time of DAY Timer Operation Step Step Other Notes on Timer Operation To USE the Hotplate HotplateHOW to Deal with a FAT Fire Safety Requirements for Deep FAT FryingTOP Oven Guidance on Using the TOP OvenTo USE the TOP Oven Meat and Poultry TOP Oven Cooking ChartYeast Mixtures Grill PAN and Handle GrillTo USE the Grill Relighting the BurnerShelf Position Food To USE the Main Oven Main OvenRoasting of Large Poultry Cold Start CookingStorage and RE-HEATING of Food ‘COOK CHILL’ DishesMain Oven Cooking Chart CAKES, Pastries and Biscuits Using the ‘SLOW COOK’ Setting for Slow Cooking ‘SLOW COOK’ SettingMain Oven Heat Clean Linings Care and CleaningReplacement of Oven Light Bulb Oven DoorsVitreous Enamel Cooker Finish Cleaning MethodSomething Wrong With Your Cooker Problem CheckSomething Wrong GAS Safety Installation & USE Regulations Installation InstructionsLocation Provision for VentilationGeneral Technical Data DimensionsCooker Hoods Space for FixingLevelling Unpacking the CookerStability Bracket Connecting to GAS Supply Connect to a 230-240V A.C. Supply only Electrical ConnectionInstallation and Operational Checks Key Contacts
Top Page Image Contents