Oven On Indicator, To Set the Clock, Tones

STOPCOOK

TIMER CLOCK TIME CLEAN TIME BROIL BAKE nDDDDDD

Oven “On” Indicator

The word “ON’ is displayed when the BAKE or the BRO~ button is pushed. It goes out when the oven CANCEL button is pushed or when the oven shuts off automatically.

The oven operation is controlled electronically. The following instructions tell you how to operate the electronic controls.

To Set the Clock

1.Wsh the CLOCK button.

2.Turn the SET knob to the correct time of day. The clock is now set. The clock must be set to the correct time of day for accurate automatic oven timing operations.

To Set the MinutdSecond Ther

1.Push the TIMER button.

2.Turn the SET knob to the desired amount of time (up to 9 hours and 59 minutes). The minute/second timer will begin to count down within a few seconds.

3.When time is up, the end of cycle tone (3 long beeps) will sound and the display will again show the time of day.

To Cancelthe Tfier

Wsh and hold the TMER button for 3 seconds while ‘TIMER’ is displayed. This will clear the minute/second timer function.

NOTE: The minute/second timer is a reminder only and will not operate the oven.

You can use the minute/second timer whether or not the oven is being used. The minute/second timer does not interfere with oven operations.

Tones

End-of-Cycle Tone (3 long beeps—1 second on,

1 second o~: shows that a timed oven operation has reached the Stop Time or that the minute/second timer has counted down.

Attention Tone (series of short beeps, l/4-second on, l/4-second off, until the proper response is given): will sound if the oven has only been partially programmed. For example, if you have selected a cook time but no temperature, you will hear the attention tone until you select a temperature or push the CANCEL button.

Notification Tone (single, 1-second beep): indicates the oven has stabilized at the selected temperature.

Key Tone (single, l/10-second beep): sounds when any button is pushed.

Function Error Tone (series of very rapid beeps, l/8-second on, l/4-second o~: display will show a code. Cancel the function error tone by pushing the CANCEL button. If the function error tone starts again (after about 15 seconds), call for service. Disconnect the range electrical supply to stop the tone.

If the function error occurred while you were programming the oven control, push the CANCEL button and try again.

To Cancel the Tone... If you don’t want an audible tone when you push a button, you can eliminate the Key Tone by pushing and holding the CANCEL button until you hear a short beep (in approximately two seconds). To activate the tone again, push and hold the CANCEL button once more until you hear a short beep. Canceling or activating the tone should only be done when there is no oven operation programmed.

Wshing the CANCEL button will clear all functions except the Clock and Minute/Second Timer.