Figure 29. Acceptable Oil Leakage
GEARBOX
DRAIN PLUG DP16
Figure 30. Drain Plug (Underside of Unit)
7.Re-install and tighten drain plug.
8.Dispose of used oil in an approved container.
9.Add SAE 85W90 gear oil through the dipstick cover. Use the dipstick to check the oil level (Figure 31) and add oil accordingly.
10.Re-install and tighten fill plug.
11.Reconnect PTO driveline and hydraulic lines.
12.Remove blocks or safety stands.
DP114
Figure 31. Dipstick Location
WHEEL SPACING
The wheels can be adjusted for alignment with crop rows.
1.Clear the area of bystanders, especially children.
2.Shut off tractor, place all controls in neutral, set parking brake, remove key, and wait for all moving parts to stop.
3.Use a jack with sufficient capacity to lift the frame.
4.To determine wheel spacing, measure from the center line of the unit. Mark positions on the frame.
5.Lift frame until wheels have cleared the ground.
6.Place safety stands or large blocks under the frame.
MAN0943 (07/12/2011) | Service & Maintenance 29 |
|
|